JVC TK-C215VP4U/E, TK-C215VP12U/E manual Inserting the silica gel supplied

Page 24

Installation and Connection

Mounting the camera unit (continued)

4. Inserting the silica gel supplied

Take out the silica gel from the aluminum package, insert it into the silica gel insertion space of the camera unit and fasten using the lug plate.

Silica Gel Insertion

Space

Silica Gel

Lug Plate

*TK-C215VP4 is used in the above illustration

Memo:

●During reconnection or re-installation after repair or maintenance, make sure to replace the silica gel with a new one.

●Consult your nearby JVC’s dealer on the replacement procedures.

Serial number of part to be replaced: Use a LW40500-001A silica gel.

Note:

●When mounting is performed on a rainy day, make sure that rain water does not enter this unit.

●Make sure to use the silica gel supplied. Failure to do so may cause the camera lens and dome cover to fog.

●If the angle of view is not adjusted immediately after mounting the camera, insert the silica gel after adjustment is completed. The silica gel loses its effect if it is exposed to the air for a prolonged period of time.

24

Image 24

Contents TK-C215VP4U/E Instructions TK-C215VP12U/E For Customer UseIntroduction Safety Precautions For USA and CanadaDear Customer Characteristics Table of Contents Precautions for proper use of this product Storage and Location of UseOthers Maintenance Energy Conservation Note on consumable parts TK-C215VP12U/E onlyName of Parts CameraAC 24 V/DC 12 V Power Supply Wire Alarm signal cable TK-C215VP12U/E onlyVideo signal output connector BNC BaseCamera Interior MemoSetting the Switches Lens TK-C215VP4U/E RESET/SPOT RESET/SPOT buttonB,+/- R/B,+/- adjustment button Function selection switches AGC Auto-gain control switchSync Synchronization system selection switch WHT.BAL. ATW/MANUAL selection switchBLC Backlight compensation switch DAY/NIGHT Easy Day & Night switchAlarm Position status indication LED B,+/- R/B, +/- adjustment buttonPosition Select Position Select button Alarm alarm input mode selection switch TriggerSystem Example Metal ContactVideo signal cables DC 12 V or AC 24 V power supply cableAbout Connection Cables Electrical Specifications of Alarm Input Terminals ‹ Polarity of alarm signalsRight sequence to connect and set the camera Setting the switches Setting the switchesRemoving the dome cover Removing the inner domeSetup Mounting the fall prevention wire to a firm placeMounting the base Removing the camera unit from the baseConnecting the coaxial cable a Pg Connecting the AC 24 V/DC 12 V power supply wiresConnect the alarm cable. TK-C215VP12U/E onlyA Pg Cable ConnectionMounting the camera unit Fill the hole with sealing materialMounting the camera unit to the base Fastening the 2 fastening screws of the camera unitInserting the silica gel supplied Adjusting the video image Adjusting the shooting direction of the cameraMounting the test monitor Adjusting the angle of view, focus and brightness Adjusting the angle of viewAdjusting the focus TK-C215VP4U/EAdjusting the brightness Adjust the focus Adjust the brightness TK-C215VP12U/E Registering home position Registering alarm position Mounting the inner dome Mounting the dome coverMounting the camera using the electrical box Following procedures are same as normal mountingMounting the camera using the pipe Mounting the fall prevention wire to a firm place a PgMounting the base to the pipe Fastening the base to the ceilingRemoving the plug for the piping hole of the base White-spot correction Page Specifications Camera Lens General Dimensional Outline Drawing Focus chart TK-C215VP4U/E TK-C215VP12U/E Dome Camera