Mounting the camera unit
Fill the piping hole and mounting hole with a sealing material, mount the camera unit to the base, and insert the silica gel.
1. Fill the hole with sealing material
Fill the piping hole as well as the 2 mounting holes mounted with screws using a sealing material.
Sealing Material
Memo:
●Use GE silicon or its equivalents as the sealing material.
Note:
●If the piping hole and the 2 mounting holes mounted with screws are not filled with sealing material completely, water or vapor may enter the holes causing the lens and dome cover to fog. Make sure that these holes are completely filled.
2. Mounting the camera unit to the base
Press the 2 clips until a “click” sound is heard.
Note:
●Mount such that the cables and fall prevention wire of the dome cover are not clamped.
3. Fastening the 2 fastening screws of the camera unit
Tighten the 2 fastening screws of the camera unit using a screwdriver to fasten the camera.
2
Clip |
(x 2) |
3 |
23