Panasonic CY-VH9300U operating instructions Operations Power and Volume Use of Range

E	IR Wireless Headphones Preparation
GN
L
I
S	Battery Installation			Battery Notes
H
9	(Inserting/Replacing the Batteries)			Battery information:
				≥ Battery type: Manganese R03, AAA, UM-4 dry
	1		1Open the battery holder	cells (supplied)
		POWER	cover.	≥ Battery life: Approximately 18 hours of continuous

		E
		N
		G
		L
		I
		S
How to Use the IR Wireless Headphones
		H
Operations (Power and Volume)	The Use of Range	10
POWER button	These headphones use infrared rays for operation.
	Use them within the range shown in the figure.

	As shown in the figure, use	operation under normal use (at room
	the tool such as a slot-head	temperature)
	screwdriver to disengage the
	bottom part of the battery	Battery life	POWER indicator
	holder cover, and then use
POWER		When operation is	Lights up green.
	your fingers to lift the top part
		possible
	free.
		When the battery needs	Dims or fails to light.
		to be replaced

POWER

Volume	Volume
up	down

(Before wearing headphones)

1Turn the volume on the headphones all the way

Plane view:	Approximately 2.5 m
	(Max)*
45x	Approximately 5 m
45x	(Max)*
	Approximately 2.5 m
Vertical view:	(Max)*

2

3

POWER

POWER

2Insert the battery. Insert the battery in the correct direction, making sure that its positive and negative ends match the same symbols in the battery holder.

3Replace the cover.

The cover is fixed in place with a click.

To check the remaining battery strength:

The POWER indicator on the right hand earpiece (R) dims or fails to light when the batteries are weak. Noise and interference also increase.

Change the batteries if any of these occur.

POWER indicator

POWER

down.

2Press the POWER button.

≥ The POWER indicator lights up.

3Turn the volume up slowly until you can hear the sound comfortably and clearly, and without distortion.

(After use)

Press the POWER button to switch off.

Note:

≥Refer to “When Listening with IR (Infrared)

30x

Approximately 2.5 m

(Max)*

*Conditions: The batteries must be fully charged and in their normal status, room temperature must be the normal temperature, and there must be no obstructions between the main unit and IR wireless headphones.

POWER

POWER (Right side)

Wireless Headphones” (page 10).

Infrared receiving port

Note:

≥One battery is required for the left and another for the right side of each headphone.

Caution:

≥Improper use of the battery may cause overheating, an explosion or ignition, resulting in injury or a fire. Battery leakage may damage the product.

≥Do not expose the IR wireless headphones to direct sunlight.

≥Do not mix old and new batteries.

≥Do not use alkaline dry cells or rechargeable type batteries. (There is the danger of liquid leakage.)

≥Do not recharge, disassemble, deform or heat the battery.

≥Do not put the battery in fire or water.

≥Immediately replace used up battery.

≥Obey local ordinances when disposing of the battery.

Note:

≥Depending on the vehicle model and amount of charge remaining in headphone batteries, the actual range of use may be less than what is given in the figures above.

≥If no infrared signals are received from the main unit for more than one minute after the headphones power has been turned on, the headphones power will be automatically turned off (auto power function).

52 CY-VH9300U CY-VH9300U 53