SETTING THE CLOCK
1.Turn the radio on so that the radio frequency or clock time is shown on the display panel.
2.Press and hold the T/F button 5 approximately 2 seconds until the time display begins flashing.
3.Press the 
to select hour adjustment and the 
to select minutes adjustment.
4.After selecting either hour or minute adjustment 
button to increment or the 
button to decrement to the correct time.
5.When the correct time is shown on the display panel, press the T/F button 5 again to return to normal display.
ERROR CODES
If a problem should develop while operating the CD player, the following error codes may be displayed on the LCD panel. E-01:Indicates an error in the unit reading the data on the disc.
E-02:Indicates an error in the laser focus on the disc. May be caused by high temperature conditions in which case play will resume when the temperature returns to normal range.
E-03:Indicates a data and focus error. May be caused by high temperature conditions in which case play will resume when the temperature returns to normal.
E-04:Indicates a mechanical error.
E-05:Indicates a problem with the loading or eject mechanism.
In case of any of the above indications, eject the disc, make sure it is clean, undamaged, and had been loaded correctly (label side up). Re-load the disc and check for proper operation or try another disc. You may also try pressing the Re-set button cuon the front of the chassis (remove the front panel), but this will also erase the time setting and pre-set memories. If these suggestions do not solve the problem, contact an approved warranty station for further assistance.
