Audiovox UCD200 owner manual Installation Instructions, Installation Using a Mounting Sleeve

Page 3

UCD200

INSTALLATION INSTRUCTIONS

Installation Using a Mounting Sleeve

1.

Slide the mounting sleeve off the chassis.

 

If it is locked into position, use the removal

 

tools (supplied) to disengage it.

2.

Check the dashboard opening size by

 

sliding the mounting sleeve into it. If the

 

opening is too small, carefully cut or file as

 

necessary until the sleeve easily slides

 

into the opening. Do not force the sleeve

 

into the opening or cause it to bend or

 

bow. Check for sufficient space behind the

 

dashboard for the radio chassis.

3.

Locate the series of bend tabs along the

 

top, bottom and sides of the mounting

5.Make sure the radio is right-side up, then carefully slide the radio into the mounting sleeve until it is fully seated and the spring clips lock it into place.

6.Attach one end of the perforated support strap (supplied) to the screw stud on the rear of the chassis using the hex nut provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or below the radio using the screw provided. Bend the strap to position it as necessary.

7.Test the radio using the Operating Instruc- tions that follow.

BEND TABS

sleeve. With the sleeve fully inserted into

the dashboard opening, bend as many of

the tabs outward as necessary to firmly

secure the sleeve to the dashboard.

4. Place the radio in front of the dashboard

opening so the wiring can be brought

through the mounting sleeve. Follow the

wiring diagram carefully and make certain

CAUTION: The support strap must be used to prevent damage to the dashboard from the weight of the radio or improper operation due to vibration.

INSTALLATION

all connections are secure and insulated

with wire nuts or electrical tape. After

completing the wiring connections, turn

the unit on to confirm operation (vehicle

ignition must be “on”). If the unit does not

operate, re-check all wiring until the

problem is corrected.

CAUTION: For proper operation of the CD player, the chassis must be mounted within 20° of horizontal. Make sure the unit is mounted within this limitation.

PCD160U

AM / FM / CD RECEIVER

3

Image 3
Contents UCD200 Preparation Installation Using a Mounting Sleeve Installation InstructionsInstallation Using a Kit ISO InstallationRemoving the Radio Amplifier Wiring WiringFaceplate Detachment Installing the Removable FaceplateFaceplate Installation Handling PrecautionsSelect Button SEL Power On/Off Button PWRLiquid Crystal Display Panel Volume Control Audio Operating InstructionsAM/FM Band Selector Band Bass Control Rear/Front Fader Control Loudness Control LOUTreble Control Left/Right Balance ControlAudio Mute MUT Tuning ControlAuto-Store / Pre-Set Scan Tuning AMS FM Mono Select MONDisplay Selector Disp Mode Selector ModeSetting the Clock Station Pre-Set MemoriesCD Player Operating Instructions Track Repeat Play Select RPT Disc Eject ButtonRandom Play Select RDM Handling Compact Discs Care and MaintenanceSpecifications Technical SpecificationsCD-R and CD-RW Capability DAY Limited Warranty UCD200 UCD200 Preparación Instalación Utilizando una Manga de Montaje Instrucciones DE InstalaciónEquipo de Instalación Instalación ISOCómo Desmontar el Radio Conector para la Antena CableadoPrecauciones al Manipular Instalación DE LA Cubierta DesmontableInstalación de la Cubierta Desprendimiento de la CubiertaBotón de Selección SEL Control de Volumen AudioInstrucciones DE Operación Botón de Encendido / Apagado PWRControl de Sonoridad LOU Control de GravesControl de Agudos Control de Balance Delantero/TraseroBúsqueda de Sintonía Control de SintoníaSelección de FM Mono MON Audio Mudo MUTSelector de Visualización Disp Selector de Modo ModeMemorias para Almacenar Estaciones de Radio Selector de Ecualizador EQFuncionamiento DEL Lector DE CD Selector de Repetición RPT 20 Botón de Expulsión de DiscoSelector de Reproducción Aleatoria RDM Manipulando Discos Compactos Cuidados Y MantenimientoEspecificaciones Técnicas EspecificacionesGarantia Limitade DE 3 Meses UCD200 Manual de LUtilisateur Préparation Installation en Utilisant un Manchon de Montage Instructions DinstallationRetrait de Radio Instructions D’INSTALLATIONInstallation de la Trousse Installation ISOCâblage Amplificateur CâblagePrécautions de Manipulation Installation DE LA Dalle AmovibleInstallation de la Dalle Détachement de la DalleBouton de Sélection SEL Contrôle du Volume AudioInstructions Doperation Bouton Puissance En Marche/En Arrêt PWRContrôle dIntensité LOU Contrôle de BasseContrôle dAigu Contrôle Équilibre Avant/ ArrièreAuto-Stockage/Syntonisation à Balayage Pré-réglé AMS Contrôle de SyntonisationSélection Mono FM MON Muet Audio MUTRégler lHorloge 14 Sélectionneur de Mode Mode13 Sélectionneur dAffichage Disp 11 Mémoires Pré-Réglée de Station17 Sélection de Balayage Piste SCN Opération DE LA Platine CDFente du Disque Fonctions Repère/Revue18 Sélection de Répétition dune Piste RPT Bouton Ejection du Disque19 Sélection du Jeu au Hasard RDM Manipulation des Disques Compacts Soin ET EntretienSpécifications Techniques Capacité CD-R et CD-RWGarantie Limitée DE 3 Mois