Audiovox UCD200 owner manual Amplifier Wiring

Page 5

UCD200

WIRING

Antenna Connector

Gray

Amplifier Wiring

Connect line out for optional external amplifiers. The red connector is for the right and the white connector is for the left.

Power Antenna

WARNING! Never combine (bridge) outputs for use with 1 speaker.

WARNING! Never ground negative speaker leads to chassis ground.

CAUTION: Failure to wire exactly as shown may cause electrical damage to the radio.

LF/AVG

White/Black (-)

White (+)

LR/ARG

Green/Black (-)

Green (+)

Blue

Black

Yellow

15A

Red

0.5A

RF/AVD

Gray/Black (-)

Gray (+)

RR/ARD

Violet/Black (-)

Violet (+)

+

Connect to power antenna or amplifier. If not used, tape bare end of wire.

Ground

Connect to ground terminal.

Memory/Battery

Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected.

Accessory/Ignition Connect to existing radio wire or radio fuse.

Fuses

When replacing a fuse, make sure the new fuse is the correct type (AGC) and amperage. Using an incorrect fuse could damage the radio.

5

Image 5
Contents UCD200 Preparation Installation Using a Mounting Sleeve Installation InstructionsRemoving the Radio Installation Using a KitISO Installation Amplifier Wiring WiringFaceplate Installation Installing the Removable FaceplateHandling Precautions Faceplate DetachmentLiquid Crystal Display Panel Volume Control Audio Power On/Off Button PWROperating Instructions Select Button SELTreble Control Bass Control Rear/Front Fader Control Loudness Control LOULeft/Right Balance Control AM/FM Band Selector BandAuto-Store / Pre-Set Scan Tuning AMS Tuning ControlFM Mono Select MON Audio Mute MUTSetting the Clock Mode Selector ModeStation Pre-Set Memories Display Selector DispCD Player Operating Instructions Random Play Select RDM Track Repeat Play Select RPTDisc Eject Button Handling Compact Discs Care and MaintenanceCD-R and CD-RW Capability SpecificationsTechnical Specifications DAY Limited Warranty UCD200 UCD200 Preparación Instalación Utilizando una Manga de Montaje Instrucciones DE InstalaciónCómo Desmontar el Radio Equipo de InstalaciónInstalación ISO Conector para la Antena CableadoInstalación de la Cubierta Instalación DE LA Cubierta DesmontableDesprendimiento de la Cubierta Precauciones al ManipularInstrucciones DE Operación Control de Volumen AudioBotón de Encendido / Apagado PWR Botón de Selección SELControl de Agudos Control de GravesControl de Balance Delantero/Trasero Control de Sonoridad LOUSelección de FM Mono MON Control de SintoníaAudio Mudo MUT Búsqueda de SintoníaMemorias para Almacenar Estaciones de Radio Selector de Modo ModeSelector de Ecualizador EQ Selector de Visualización DispFuncionamiento DEL Lector DE CD Selector de Reproducción Aleatoria RDM Selector de Repetición RPT20 Botón de Expulsión de Disco Manipulando Discos Compactos Cuidados Y MantenimientoEspecificaciones Técnicas EspecificacionesGarantia Limitade DE 3 Meses UCD200 Manual de LUtilisateur Préparation Installation en Utilisant un Manchon de Montage Instructions DinstallationInstallation de la Trousse Instructions D’INSTALLATIONInstallation ISO Retrait de RadioCâblage Amplificateur CâblageInstallation de la Dalle Installation DE LA Dalle AmovibleDétachement de la Dalle Précautions de ManipulationInstructions Doperation Contrôle du Volume AudioBouton Puissance En Marche/En Arrêt PWR Bouton de Sélection SELContrôle dAigu Contrôle de BasseContrôle Équilibre Avant/ Arrière Contrôle dIntensité LOUSélection Mono FM MON Contrôle de SyntonisationMuet Audio MUT Auto-Stockage/Syntonisation à Balayage Pré-réglé AMS13 Sélectionneur dAffichage Disp 14 Sélectionneur de Mode Mode11 Mémoires Pré-Réglée de Station Régler lHorlogeFente du Disque Opération DE LA Platine CDFonctions Repère/Revue 17 Sélection de Balayage Piste SCN19 Sélection du Jeu au Hasard RDM 18 Sélection de Répétition dune Piste RPTBouton Ejection du Disque Manipulation des Disques Compacts Soin ET EntretienSpécifications Techniques Capacité CD-R et CD-RWGarantie Limitée DE 3 Mois