TROUBLE-SHOOTING AND MAINTENANCE
Inspectand tighlenall parts each time you usethe CROSS TRAINERe. Replace any warn parts immediately. Outside surfacesof the CROSS TRAINERe can be cleaned using a damp clothand mild detergent. Keep all liquids away from the stepperconsole and the PERSONALTRAINER computer. Most CROSSTRAINER• problems can be solvedby follow- ing the slaps below. Find the applicable symptom and fallow the slap(s)lided. If further assistanceis needed, call our Customer ServiceDepadment
.time (excluding holidays).
1.SYMPTOM: THE PERSONALTRAINER COMPUTER DISPLAYS AN ERROR CODE ("EEE")
a.While theweightsettingischanging, the motorwillbeheardandtheSETSandREPSdisplayswillshowa rapidly rotatingindicator. To preventdamage to the weight system,do not put any pressureon the leg developer,arms or cableswhile the weight settingischanging. Ifthe tat bar or rower bar is attached to the high pulley station,restit in the rock near the high pulleystation.Wait for.the soundof the motorto stop before you continue. If the comput- er sensespressure on the weight systemwhile the weight settingischanging, the WEIGHT display will show an
•error code ("EEE")for two seconds,and the weight settingwill
2.SYMPTOM: THE MAIN CABLE DOES NOT MOVE SMOOTHLY, OR THERE IS SLACK IN THE MAIN CABLE
a. Inspectthe routingof thecables and make sure that they are in the grooves in all of the pulleys.If they are not, tarred the problem. If the cables are not properly routed, they will be damaged when used..
b. If there is slackin the Main Cable (51), locate the AdjustmentBracket(53) near the bottom of the
.... right side shield.Hold the end of the Weight Cable
(52) firmly, and slidethe Adjustment Bracket far- ther ontothe Weight Cable. Tighten the 5/16" Nut (82) ogaiest the AdjustmentBracket. Testthe Main Cable. If the mator stallsor hesitates,loosen the
5/16" Nut slightly.If the 5/16" Nut is tightened as far as passible and there is still slack, the Main
Cable shouldbe replaced. See ORDERING
REPLACEMENTPARTSon the back cover of this
ownerls monuok |
| 51 |
|
3.- SYMPTOM:THE STEPPERCONSOLE DOES NOT |
|
|
|
FUNCTION PROPERLY |
|
|
|
a, As you step, movethe stepper pedals vertically at |
|
| 99 |
least 8 inches.If)our stepsare too shallow, the |
|
| / |
movementof the stepperpedals will not be detect- |
| 120 | IE |
ed. If the stepperconsolestilldoes not function |
|
| |
|
| \ | |
properly, the Reed Switch(99) con be adjusted by |
|
| |
|
|
| |
sliding the barrel of the ReedSwitch up and down |
|
| \ |
slightly. Repeatuntil the stepperconsole displays |
|
| _ounting |
correctfeedback. If necessary,the 3/4" Screw | I | 119/ | eeye |
|
|
|
(119} attaching the Reed Switch Bracket(120) can
be loosenedand the positionof the Bracket can be
adjusted.
25