10.Wrap the Weight Cable (52) around a 2" Pulley (4). Attach the Pulleyto the RightArm (16) with a 3/8" x 1 3/4" Bolt(40) and 3/8" Nylock Nut (6).
Lay theWeight Cable (52) over a 3 1/2' Pulley(5). Attach a Cable Trap (67) and the Pulley to the side of the Upright (9) with a 3/8" x 1 3/4' Bolt (40) and 3/8' Nylock Nut (6). Make sure that the Cable Trap is in the "12 o'clock"position.
11.Wrap the Weight Cable (52) under a 2" Pulley (4). Attach the Pulleyto the bracket on the side of the
Moment Arm (74) with a 3/8" x 1 3/4" Bolt(40) and 3/8" Nylock Nut (6). Make sure that the Weight. Cable is between the Pulleyand the indicated tab.
Attach the end of the Weight Cable (52) to the right side of the Leg Developer (23) with a 3/8' x 2 1/4" Boil (45) and 3/8" Nylock Nut (6). Do not over'llght- en the Nylock Nut, the Cable must be able Io swiv- el freely or it will be damaged.
12.Insertthe threaded bolt on the end of the Weight Cable (52) into the Adjustment Bracket (53). Finger tighten the 5/16" Nut (82) onto the threaded bolt until there is slight tension in the Cable.
13.Wet the upper ends of the left and Right Arms (15,
16)and the insidesof the two Large Pads (17) with soapy water. Slide the Large Pads onto the Arms.
Altoch the Backrest(19) to the Upright (9) with two 1/4' x 2 1/2" Bolts (46).
12
13
17
1
6