NordicTrack 831.29881 Maintenance and Trouble-shooting, Symptom the Power does not Turn on, Reset

Page 20

Maintenance and Trouble-shooting

Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-888-825-2588, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

1.SYMPTOM: THE POWER DOES NOT TURN ON

a.Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 10). Use only a single-outlet surge suppressor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppresser must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically rated for 120 volts AC and 15 amps.

b.After the power cord has been plugged in, make sure that the key is fully inserted into the console. (See step 2 on page 12.)

c. Check the cfrcuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in,

d. Check the on/off switch located at the front of the treadmill near the power cord. The switch must be in the on position.

c

Tripped

Reset

OnPosition

2.SYMPTOM: THE POWER TURNS OFF DURING USE

a. Check the circuit breaker located on the treadmill frame breaker has tripped, wait for five minutes and then press

near the power cord (see 1. c. above). If the circuit the switch back in.

b. Check to make sure that the on/off switch is in the on position. (See 1. d. above.)

c. Make sure that the power cord is plugged in.

d. Remove the key from the console. Reinsert the key fully into the console. (See step 2 on page 12.)

e. If the treadmill stiti will not run, please call our Customer Service Department toll-free.

3.SYMPTOM: AN ERROR CODE ("El," "E20," "E21," "E22," "E23," OR "E24") APPEARS ON THE CONSOLE

a.If the console detects an incline error, an "El" may appear in the INCLINE/DISTANCE display when the INCLINE buttons are pressed, and when the display shows the current incline level. If this error code appears, remove the key from the console, wait for ten seconds, and then reinsert the key. If the error code appears again, call our Customer Service Department. Do not operate the treadmill until the problem is corrected,

b.If the console detects a speed error (no speed signal, an erratic speed signal, etc.), an "E20," "E21," "E22," "E23," or "E24" may appear in the SPEED display. If one of these error codes appears, remove the key from the console, wait for ten seconds, and then reinsert the key. If the error code appears again, call our Customer Service Department. Do not operate the treadmill until the problem is corrected.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Questions? Model No Serial NoCustomer HOT Line Mon.-Fri., 6 a.m.--6 p.m. MSTTable-of Contents 2i Use th Inspect and tighten all parts of every three monthsOn each side Before You Begin Assembly Page How to Use the CardioTrack Heart Rate Monitor HOW to PUT on the Heart Rate MonitorHeart Rate Monitor Care and Maintenance Counterclockwise to the the cover BatteryThis product must be grounded. If it should malfunc HOW to Plug in the Power CordPerformant Lube TM Walking Belt Diagram of the Console Features OftheconsoleDesired Plug Power Cord Manual ModeSTART/ENTER Button Or the Speed + button to start the walking beltFollow your progress with the five displays Pulse display TIME/PACE displaySpeed display DISTANCE/INCLINE displayEnter your weight if desired Insert the key fully into the consoleLPut on the CardioTrack heart rate monitor Pressed, the currentFollow your progress with the five displays IZI HOW to Select the Information Mode TIME/PACE display will show the total numberHOW to Move the Treadmill How to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Hold the upper end of the treadmill with your right hand asMaintenance and Trouble-shooting Symptom the Power does not Turn onReset Symptom the Power Turns OFF During USESymptom the Walking Belt Slows When Walked on Symptom the Heart Rate Monitor does not FUNCrlON ProperlySymptom the Walking Belt is OFF-CENTER When Walked on Conditioning Guidelines EtEstablish personal fitness goalsDetermine your target heart rate Target Heart Rate ZonesWarm up before you begin Stretch after your warm-upElGet FIT with the PowerTread Cool down after aerobic exerciseEl Stretch again at the end of your exercise session ElParticipate in strength trainingHead Ratelntensity Part ListRModei R0399A Receiver Screw--Long Qty Description Key Io. QtyWheel Spacer LO0 1O0 107 43\ Exploded DrawingmModel No 102Limited Warranty
Top Page Image Contents