Grizzly Ultimate Manual for One Shot Oiler Lubrication on Treadmills

NOTICE

Failure to follow the lubrication practices outlined in this manual could lead to pre- mature failure of your mill and void the war- ranty.

One-Shot Oiler

Lubricant	Frequency	Qty
ISO 68 Lubricant or	Every	1
Equivalent	8 Hours	Pump
	of Operation

The oil lines running from the one-shot oiler feed lubrication to the ways of the column (knee), saddle, and table.

Use the sight glass on the front of the oiler to make sure it is full, then pull the handle (see Figure 54) and release it to send lubricant through the lines.

Fill Cap

Oil Line

One-Shot

Pump

Handle

Figure 54. One-shot oiler.

-36-

Quill Gearing

Lubricant	Frequency	Qty
ISO 68 Lubricant or	Every	5
Equivalent	8 Hours	Drops
	of Operation

Lift the cap of the oil cup shown in Figure 55 to add the lubricant.

Quill Gearing

Oil Cup

Figure 55. Quill gearing oil cup.

Vertical Bevel Gears

Lubricant	Frequency	Qty
NLGI #2 Grease	Every	Thin
	40 Hours	Coat
	of Operation

Raise the knee up to access the vertical bevel gears underneath the saddle, then clean and lubricate the bevel gears shown in Figure 56.

Bevel Gears

Figure 56. Vertical bevel gears.

Model G0695 (Mfg. Since 9/10)