NordicTrack NTB49030 Side Top Frame 7. Make sure that the Cable, Cated rods on the Swivel Arm

29. Route the Cable Tool (27) through the indicated	29
Side Top Frame (7). Make sure that the Cable
	Cable Tool
Tool is routed around the bolts in the Top
	Path				7
Frame as indicated; if the High Cable (54) rubs
against a bolt, damage may occur.
Locate the High Cable (54). Thread the end of
the Cable without the Clip (42) into the Cable Tool
(27). Make sure the Cable is inside of the indi-	Rod
cated rods on the Swivel Arm (14).
Pull the High Cable (54) through the Side Top	27
Frame (7) and remove it from the Cable Tool (27).		14
	54
	Rod	42
30. Attach a 4” Pulley (89) inside the Swivel Arm (14)	30
with an M10 x 54mm Button Bolt (73), two M10
Washers (65), two 7mm Spacers (48), and an
M10 Nylon Locknut (62). Make sure the High
Cable (54) rests in the groove of the Pulley.
		14
	73
		65	65 62
		48	48
		54	89
31. Route the High Cable (54) around a 3 1/2” Pulley	31			74
(45) and through the bracket on the Center Top
Frame (2). Attach the Pulley inside the bracket				2	62
with an M10 x 48mm Button Bolt (74) and an M10
Nylon Locknut (62).				54
					45
32. Route the High Cable (54) around a 3 1/2” Pulley	32
(45) and through the indicated tube on the Center
				2
Top Frame (2). Make sure the Cable is routed
		74
over the bolts as indicated.
Attach the 3 1/2” Pulley (45) to Center Top Frame
(2) with an M10 x 48mm Button Bolt (74) and an			45	Cable
M10 Nylon Locknut (62).
				Path
				54
		62
	13