46. Route the Low Cable (55) around a 3 1/2” Pulley | 46 |
|
|
(45) and through the bracket on the Base (1). |
|
| |
| 55 | 62 | |
Attach the Pulley inside the Base with an M10 x |
| ||
|
|
| |
48mm Button Bolt (74) and an M10 Nylon |
|
| 45 |
Locknut (62). Make sure the Cable is in the |
|
|
|
groove of the Pulley. |
|
|
|
|
| 1 |
|
|
|
| 62 |
47. Wrap the Low Cable (55) around a 3 1/2” Pulley | 47 |
|
|
(45). Attach the Pulley inside the bracket on the |
|
| |
|
| 45 | |
Stabilizer (1) with an M10 x 48mm Button Bolt |
| 55 | |
| 74 | ||
(74) and an M10 Nylon Locknut (62). |
|
|
|
|
|
| 1 |
|
|
| 62 |
48. Thread the end of the Low Cable (55) into the | 48 |
|
|
Cable Tool (not shown). Route the Cable Tool and |
|
| |
|
|
| |
Cable through the Right Stabilizer (6). Make sure | 48 |
|
|
that the Cable Tool is routed around the bolts | 55 |
| |
|
| ||
in the Stabilizer as indicated; if the Cable rubs | 62 | 89 |
|
against a bolt, damage may occur. Remove the |
| ||
| 48 |
| |
Cable from the Cable Tool. Make sure the Low |
|
| |
Cable is routed over the rods on the Swivel | 65 |
|
|
Arm (14). |
|
| |
14 |
| 6 | |
|
| ||
Attach a 4” Pulley (89) inside the Swivel Arm (14) | Rods |
|
|
with an M10 x 54mm Button Bolt (73), two M10 |
|
| |
|
|
| |
Washers (65), two 7mm Spacers (48), and an |
| 65 | 73 |
M10 Nylon Locknut (62). Make sure the Low |
|
|
|
Cable (55) rests in the groove of the Pulley. |
|
|
|
| 49 | 42 |
|
49. Slide a Clip Cover (43) onto the Low Cable (55). |
| 63 | |
|
| 43 | |
Hold an M6 Nylon Locknut (63) inside a Clip (42), |
|
| |
|
|
| |
and insert the Low Cable (55) into the Clip and |
| 55 |
|
the Locknut. Insert a screwdriver between the |
|
| |
|
|
| |
Locknut and the Clip. Rotate the screwdriver, the |
|
|
|
Clip, and the Locknut together until two threads of |
|
|
|
the Cable show past the Locknut. |
|
|
|
Slide the Clip Cover (43) over the Clip (42). | 50 | 32 |
|
|
|
| |
50. Press two Oval Caps (32) into the Base (1). |
|
|
|
|
|
| 32 |
|
| 1 |
|
| 17 |
|
|