Diamondback 1190 Er manual Fatburner Program

119OM 8/28/06 11:43 AM Page 37

Workout Programs, continued

Ending the Program

•When the selected program time is up or the “STOP” key is pressed, there will be a beep to signify the end of the program and Cool Down will become active

•The message window will scroll the messages “THE PROGRAM ENDED” then “3:00 COOL DOWN BEGIN”

•The “Start” key can be pressed to re-start the program.

•The “Stop” key can be pressed to skip the cool down mode and activate the Workout Summary immediately.

FATBURNER PROGRAM

Getting Started

The Fatburner program provides a consistent level of work (65% of Max HR) during your exercise session to maximize the burning of body fat. The 1190 will adjust the intensity level to maintain 65% Max HR during the program. The profile on the Dot Matrix display will show % Max HR for this program rather than intensity level. The profile is replaced with LEDs indicating your actual achieved HR as the program exe- cutes. The LEDs will blink to show your current position in the HR profile.

Beginning the Program

Start pedaling the unit. The message window will scroll a message “SELECT A PRO- GRAM”. Press the HR Interactive Programs key until the Fatburner program LED indica- tor lights up.

Accepting Default values or Entering the program setting mode

When the message display flashes, “FAT BURNER”, it indicates you are about to select the Fatburner program. The message display will scroll “PRESS ENTER TO ADJUST OR START TO BEGIN”.

•Press “START” key to accept current default values and begin Fatburner program workout.

•Or press “ENTER” key to enter program setup mode. The message display will bring you through the program setup step by step as below:

Entering Age

1.If ENTER key is pressed, the message window will flash once, “ENTER YOUR AGE”, then “AGE = XX” will start blinking.

2.Press “UP/DOWN” key to adjust the age.

3.After age is adjusted, then press “ENTER” key to accept.

Entering Weight

1.If ENTER key is pressed, the message window will flash once, “ENTER YOUR WEIGHT”, then “WEIGHT = XX” will start blinking.

2.Press “UP/DOWN” key to adjust the weight.

3.After weight is adjusted, then press “ENTER” key to accept.

Entering Program Time

1.If ENTER key is pressed, the message window will flash once, “ENTER PROGRAM TIME”, then “TIME = 30 MIN” will start blinking.

2.Pressing “UP/DOWN” key to adjust the time. When the time setting reaches 60 minutes, the display will show “TIME = 1HR 00MIN”.

3.After time is adjusted, the message window will display “SET UP COMPLETED” “PRESS START TO BEGIN”. You may press the “START” key to begin this program.

PROGRAM

PROFILE

	35
1190 Er Owner’s Manual