Bowflex TC5000, TC1000, TC3000 manual Connecting Speed Pickup Wire, Attaching Teeter

Assembly Guide

Step 2: CONNECTING SPEED PICKUP WIRE

Locate the following for this step:

PARTS:

•TreadClimber® Base & Treadle Assembly from Step 1.

2-1Connect the speed pickup wire from base assembly and left rear roller casting (see Figure 2-1 & 2-2).

Speed pickup

wire from base.

Speed pickup

wire from left rear

roller casting.

Figure 2-1

Note: Speed pickup needs to be about 1/8" from the pulley and the red speed pickup cap is flush to the left drive bracket/roller casting.

Figure 2-2

Step 3: ATTACHING TEETER

Locate the following for this step:

PARTS:

•TreadClimber® Base & Treadle Assembly from Step 2.

HARDWARE:

•One (1) 3/8” x 3-3/4” Shoulder Bolt

•One (1) 5/16” Nylock Nut

TOOLS:

•3/16” Hex Key (included)

•9/16” Open End Wrench (included)

•Scissors or other cutting tool

3-1Carefully set unit up on its right side. This will have the pulley side up and expose underneath side of unit (see Figure 3-1).

3-2Using the 3/8" x 3-3/4" shoulder bolt and 5/16" nylock nut attach the teeter assembly to base frame (see Figure 3-2). Tighten using the 3/16" hex key and 9/16" open end wrench

(see Figure 3-3).

3-3Cut wire tie from teeter stop brackets.

Note: Manipulation of the teeter and or treadles may need to occur to line up all the holes.

Figure 3-1

Figure 3-2

Figure 3-3

15 Bowflex® TreadClimber® Owner’s Manual