Selecting a U.S. Standard or Metric Display
The EFX can display measurements in either U.S. Standard (U.S. STD) or METRIC. The default factory setting is set to display U.S. STD. To change this setting, perform the following steps:
1.At the Precor banner, press the following keys in sequence and without pause:
RESET, QUICKSTART, ENTER, SELECT [USER 2], CROSSRAMP ▲
Note: No CROSSRAMP keys exist on the EFX5.33. Use the RESISTANCE ▲ key on the left side of the keypad.
As shown in Diagram 10, numbers are associated with the keypad. The numbers 5, 6, 7, 1 appear on the display as you press the associated key.
EFX5.23
1 |
|
|
|
|
| 9 |
2 | 3 | 4 | 5 | 6 | 7 | 8 |
|
|
|
|
| ||
EFX5.33 |
|
|
|
|
|
|
1 |
|
|
|
|
| 9 |
2 | 3 | 4 | 5 | 6 | 7 | 8 |
|
|
|
|
|
Diagram 10: Keypad programming numbers
2.SELECT UNITS appears, followed by the current unit of measure (U.S. STD or METRIC). Use an arrow key to switch between the options.
3.Press ENTER to accept the displayed setting.
The change will be retained in memory even if the EFX is turned OFF and unplugged.
4.Press RESET to return to the Precor banner.
Owner’s Manual: Advanced Programming and Troubleshooting | 43 |