Timex M850 Switching time zones, Synchronizing the Watch with the GPS-3D Sensor, Hold For Time

Switching time zones

The Watch can track two time zones (T1 and T2). Look at the second zone by pressing START/SPLIT or, switch from T1 to T2 using these steps:

1.Press and hold START/SPLIT until HOLD FOR TIME 2 appears.

2.Continue to hold until the time switches and the Watch beeps.

3.Repeat steps 1 and 2 to switch back to T1. The message will read

HOLD FOR TIME 1.

Note that you must independently set the time of day for each time zone.

Synchronizing the Watch with the GPS-3D Sensor

When you first activate the GPS-3D Sensor with your Watch, you can expect one of the following scenarios:

➤If you activate the GPS-3D Sensor before setting time of day, the Watch will synchronize both T1 and T2 with UTC. You will need to adjust the hour for both time zones to your local time.

➤If you activate the GPS-3D Sensor after setting the time of day, the Watch maintains the hour and date settings and synchronizes minutes and seconds to UTC for each time zone.

➤Note that you cannot adjust the seconds when you enable the GPS features; they will always remain synchronized to UTC time.

22

Viewing performance data in Time of Day Mode

When using the Fitness Sensors with your Watch, you can scroll through performance data by pressing and releasing DISPLAY. You may elect to continue viewing the day of the week instead by pressing DISPLAY until the day of the week becomes visible.

Press to view

performance data

Performance data

You can view:

➤Heart Rate: Current heart rate expressed as either percent of your maximum heart rate (PERCENT) or beats per minute (BPM)

➤Speed: Current velocity

➤Pace: Current velocity, expressed in minutes per selected distance unit, such as miles or kilometers

➤Distance: Distance traveled since you began operating the chronograph

➤Altitude: Current elevation above sea level

23