111 | Weider 831.154021 guide

27.Wrap the Press Cable (109) around a "V"-pulley (62). Attach the "V"-pulley, two Half Finger Guards (66), a Large Cable Trap (111), and an MIO Washer (99) inside the bracket on the Left Upright (26) with an MIO x 65mm Bolt (77) and an M10 Nylon Locknut (90). Make sure the

Cable Trap and Finger Guards are oriented as shown.

-111

/66

28.Wrap the Press Cable (109) around a 90mm Pulley (63). Attach the Pulley, two Half Finger Guards (66), a Cable Trap (68), and an MIO Washer (99) to the Press Frame (29) with the MIO x 135mm Bolt (70) used in step 26 and an MIO Nylon Locknut (90). Make sure the Cable

Trap and Finger Guards are oriented as shown.

29. Wrap the Press Cable	(109) under a 90mm
Pulley (63). Attach the	Pulley, two MIO Washers
(99), and two Half Finger Guards (66) inside the
bracket on the Left Base (25) with an MIO x

90/

109

66 90

63 2

50mm Bolt (64) and an MIO Nylon Locknut (90).

Make sure the Finger Guards are oriented as

shown.

30.Wrap the Press Cable (109) over a 90mm Pulley (63). Attach the Pulley and a Cable Trap (68) to the Right Top Frame (5) with an MIO x 45mm Bolt (80) and an MIO Nylon Locknut (90). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley.

109

80 68