41.Route the Weight Cable (110) over a 90mm Pulley (63) and down through the Right Top Frame (5). Attach the Pulley inside the Top Frame with an MIO x 80mm Bolt (75), two MIO Washers (99), two MIO x 19mm Spacers (102), and an MIO Nylon Locknut (90).
42.Wrap the Weight Cable (110) under a 90mm Pulley (63). Attach the Pulley, a Cable Trap (68), and two Half Finger Guards (66) at the second hole from the top of the two Pulley Plates (51) with an MIO x 50mm Bolt (64) and an MIO Nylon Locknut (90). Make sure the Cable Trap and Finger Guards are oriented as shown.
43.Wrap the Weight Cable (110) over a 90mm Pulley (63). Attach the Pulley to the indicated bracket on the Right Top Frame (5) with an MIO x 45mm Bolt (80) and an MIO Nylon Locknut (90).
44.Wrap the Weight Cable (110) over a 90mm Pulley (63). Attach the Pulley and a Cable Trap (68) to the indicated bracket on the Right Top Frame (5) with an MIO x 45mm Bolt (80) and an MIO Nylon Locknut (90). Make sure the Cable Trap is ori- ented to hold the Cable in the groove of the Pulley.
45.Set the M12 Washer (33) on top of the Weight Tube (47). Thread the M12 Nut (49) all the way onto the Weight Cable (110).
Thread the Weight Cable (110) into the Weight Tube (47) a couple of turns.
41
75
<102
99
90
110
63
66
51
51
43Bracket
5
44 Attach
on
90
45
17