46.Locate the Ab Cable (107). Route the small ball on the Cable through the Leg Lever (4) and the Right Seat Frame (3). Make sure the Cable is over the rod in the Seat Frame.
Attach a 90mm Pulley (63) inside the Leg Lever (4), over the Ab Cable (107), with an MIO x 65mm Bolt (77), two MIO Washers (99), two MIO x 12mm Spacers (101), and an MIO Nylon Locknut (90).
47.Attach a 90mm Pulley (63) inside the Right Seat Frame (3), over the Ab Cable (107), with an MIO x 45mm Bolt (80) and an MIO Nylon Locknut (90).
48.Route the Ab Cable (107) through the Right Upright (2) and under a 90mm Pulley (63). Attach the Pulley and two Half Finger Guards (66) to the Right Base (1) with an MIO x 50mm Bolt (64) and an MIO Nylon Locknut (90). Make sure the Finger Guards are oriented as shown.
49.Wrap the Ab Cable (107) over a 90mm Pulley (63). Attach the Pulley, a Cable Trap (68), and two Half Finger Guards (66) to the lower hole in the indicated
Make sure the Cable Trap and Finger Guards are oriented as shown.
46
Large
Ball
107
47
90
48
49
Rod
77
80
90
63
5O
66
64
18