Weider 831.154021 user manual 104062

31.Attach the end of the Press Cable (109) to a "U'- bracket (50) with an M8 Washer (98) and an M8 Nylon Locknut (91). Note: Do not completely tighten the Locknut; it should be tightened so that only two threads of the Cable show past the Locknut, as shown in the inset drawing.

32. Locate the Butterfly Cable (106). Grease an M8	32
x 22mm Shoulder Bolt (39). Attach the Cable to
the Left Butterfly Arm (6) with the Bolt and an M8
Nylon Locknut (91). Make sure the flat edge of
the Cable is against the Butterfly Arm.

33. Wrap the Butterfly Cable (106) over a "V'-pulley 33

(62). Attach the "V'-pulley, a Large Cable Trap (111), an M10 Washer (99), and two Full Finger Guards (104) to the Right Upright (2) with an M10 x 62mm Bolt (73) and an M10 Nylon Locknut (90).

34. Wrap the Butterfly Cable (106) under a 90mm	34
Pulley (63). Attach the Pulley and two Half Finger
Guards (66) to the Double "U'-bracket (61) with
an M10 x 48mm Bolt (84) and an M10 Nylon
Locknut (90). Make sure the Finger Guards are
oriented as shown.

35. Wrap the Butterfly Cable (106) over a "V'-pulley	35
(62). Attach the "V'-pulby, a Large Cable Trap
(111), an M10 Washer (99), and two Full Finger
Guards (104) to the Right Upright (2) with an M10
x 62mm Bolt (73) and an M10 Nylon Locknut
(90).

)9.

- 98

50 91

90 106

111

73

104

99 104

106

61

84

_73

104062

99 _ Z lO6

___111' _'_ @

15