Whirlpool W10054080A manual PlanVentSystem, Alternate installations for close clearances

PlanVentSystem

Choose your exhaust installation type

Recommended exhaust installations

Typical installations vent the dryer from the rear of the dryer.

	B
	C
	D
A	E
	F
	G
	B
	H
A. Dryer	E. Clamps
B. Elbow	F. Rigid metal or flexible metal vent

C. Wall	G. Vent length necessary to connect
D. Exhaust hood	elbows
	H. Exhaust outlet

Standard exhaust installation with rigid metal or flexible metal vent

NOTE: The following kits for close clearance alternate installations are available for purchase. Please see the “Assistance or Service” section of this manual to order.

■Over-the-Top Installation: Part Number 4396028

■Periscope Installation (For use with dryer vent to wall vent mismatch):

Part Number 4396037 - 0" (0 cm) to 18" (45.72 cm) mismatch

Part Number 4396011 - 18" (45.72 cm) to 29" (73.66 cm) mismatch

Part Number 4396014 - 29" (73.66 cm) to 50" (127 cm) mismatch

■Rear exhaust installation to left or right side: Part Number 8212504

Special provisions for mobile home installations

The exhaust vent must be securely fastened to a noncombustible portion of the mobile home structure and must not terminate beneath the mobile home. Terminate the exhaust vent outside.

Alternate installations for close clearances

Venting systems come in many varieties. Select the type best for your installation. Two close-clearance installations are shown. Refer to the manufacturer’s instructions.

ABC

A. Over-the-top installation (also available with one offset elbow)

B. Periscope installation

C. Rear exhaust installation to left or right side

Determine vent path

■Select the route that will provide the straightest and most direct path outdoors.

■Plan the installation to use the fewest number of elbows and turns.

■When using elbows or making turns, allow as much room as possible.

■Bend vent gradually to avoid kinking.

■Use the fewest 90° turns possible.

Determine vent length and elbows needed for best drying performance

■Use the following Vent system chart to determine type of vent material and hood combinations acceptable to use.

NOTE: Do not use vent runs longer than those specified in the Vent system chart. Exhaust systems longer than those specified will:

■Shorten the life of the dryer.

■Reduce performance, resulting in longer drying times and increased energy usage.

The Vent system chart provides venting requirements that will help to achieve the best drying performance.

9