Miele How to Turn Off Dryer Buzzer for T 7634: Complete Guide

Page 46

Programmable functions

Adjusting buzzer volume

The buzzer has two volumes.

For programming and saving in memory, follow steps to .

This function is programmed using the buttons.

Precondition:

–The dryer is switched off.

–The door is closed.

Press Start/Stop and keep it pressed it during steps -.

Press the I-On/0-Offbutton in.

Wait until the Start/Stop button lights up continuously . . .

. . . then release the Start/Stop button.

Press the Gentle button once.

–The Gentle indicator light flashes briefly four times.

–P and 0 flash alternatingly in the display (default setting).

The number appearing alternatingly with P means:

0Buzzer normal (default setting)

IBuzzer loud

(Express indicator light also flashes)

Pressing the Start/Stop button switches from one number to the other, and you simultaneously hear the buzzer setting.

Using the I-On/0-Offbutton, switch the dryer off.

The programming is now stored in memory. You can change it again at any time.

46

Image 46

Contents Operating Instructions Vented dryer 7634 Disposing of your old appliance Caring for the environmentDisposal of packing material Saving energyContents Contents Important Safety Instructions This dryer is intended for residential use only Grounding InstructionsAccessories Control panel Fault indicator / Optical interfaceOperating the dryer DisplayProgram duration/ Estimated time remaining DelayProgrammable functions Drying tips Care symbolsLaundry care DryingLaundry care Preparing the laundry Proper dryingBrief instructions Turn on the dryerSelect program Extra options/Select DelayDryness level selection in programs Before the end of a program Starting the programEnd of program Remove laundry Gentle Options/DelayDelay BuzzerHand iron, Rotary iron Program OverviewNormal Extra dry, Normal Wrinkle-free Extra dry, Normal, Hand ironExpress Normal, Hand iron WoolensSmoothing Dress shirts Normal, Hand ironTimed cold Timed warmLoading or removing laundry Switching over from a running programChanging the program sequence Time remainingActivating the lock Electronic lockDeactivating the lock Cleaning the lint screen without water Cleaning and careCleaning door lint filter Cleaning the lint screen with waterCleaning port-hole grilles Cleaning the dryerTest and fault messages Trouble shootingWhat to do, if . . . ? Cancelling the fault Problem Cause SolutionCancelling a Light goes onOther faults Charged after drying Problem Cause Solution Synthetic-fiber laundryItems are statically There has been a lintCold programs will not Start and the indicatorWhen switched on Lights for these programsReplacing the light bulb Warranty conditions and warranty period Customer serviceProgram updates Optional accessoriesInstallation and connection Front viewCarrying the dryer to the installation site Rear view Installation siteWasher-dryer stack Ventilating the installation area Leveling the dryerElectrical connections General Installing the dryer ventProcedure AvoidCalculating total duct length Arrangement Left or right dryer vent openingAt the rear Rear or side exhaust connectionCalculation example Sideways to left or rightFlexible metal duct hose Overview of vent systemsExamples are shown on the next Examples Dryer vent systems from metal piping ExampleConnecting directly to a wall Side view vent Vent collector duct Washer-dryer stack Technical data Programmable functions for changing Standard values Programmable functions Extending the range of drying levelsBuzzer normal default setting Buzzer loud Adjusting buzzer volumeFor programming and saving in memory, follow steps to Set memory function No Memory default settingMemory Extending cooldown time Default setting Change function of Filter/Vent indicationAdjust keypad tone No Keypad tone default setting Keypad tone onDefault setting Lower conductivity setting Changing water conductivity settingImportant condition Alteration rights reserved Nr 323 240