Miele T 7634 operating instructions Replacing the light bulb

Page 28

Trouble shooting

Replacing the light bulb

Disconnect the dryer from the electrical supply.

Open the door.

The bulb should be of the same type and maximum wattage indicated on the data plate and the lighting cover.

Replace the bulb.

The hinged cover for the lighting is over the port-hole.

Gently insert an ordinary tool* under the side of the cover.

* such as a wide slot-type screwdriver

Open the cover by pressing lightly while rotating your wrist.

The cover opens downwards.

The heat-resistant bulb should be obtained only from Miele customer ser- vice.

Fold the cover upwards and press it on the right and left until you hear it latch.

Ensure that the cover is properly seated. If moisture gets inside it may cause a short-circuit.

28

Image 28

Contents Operating Instructions Vented dryer 7634 Caring for the environment Disposal of packing materialDisposing of your old appliance Saving energyContents Contents Important Safety Instructions This dryer is intended for residential use only Grounding InstructionsAccessories Fault indicator / Optical interface Operating the dryerControl panel DisplayProgram duration/ Estimated time remaining DelayProgrammable functions Care symbols Laundry careDrying tips DryingLaundry care Proper drying Brief instructionsPreparing the laundry Turn on the dryerSelect program Extra options/Select DelayDryness level selection in programs Before the end of a program Starting the programEnd of program Remove laundry Options/Delay DelayGentle BuzzerProgram Overview Normal Extra dry, NormalHand iron, Rotary iron Wrinkle-free Extra dry, Normal, Hand ironWoolens SmoothingExpress Normal, Hand iron Dress shirts Normal, Hand ironTimed cold Timed warmSwitching over from a running program Changing the program sequenceLoading or removing laundry Time remainingActivating the lock Electronic lockDeactivating the lock Cleaning and care Cleaning door lint filterCleaning the lint screen without water Cleaning the lint screen with waterCleaning port-hole grilles Cleaning the dryerTest and fault messages Trouble shootingWhat to do, if . . . ? Problem Cause Solution Cancelling aCancelling the fault Light goes onOther faults Problem Cause Solution Synthetic-fiber laundry Items are staticallyCharged after drying There has been a lintStart and the indicator When switched onCold programs will not Lights for these programsReplacing the light bulb Customer service Program updatesWarranty conditions and warranty period Optional accessoriesInstallation and connection Front viewCarrying the dryer to the installation site Rear view Installation siteWasher-dryer stack Ventilating the installation area Leveling the dryerElectrical connections Installing the dryer vent ProcedureGeneral AvoidCalculating total duct length Arrangement Left or right dryer vent openingRear or side exhaust connection Calculation exampleAt the rear Sideways to left or rightFlexible metal duct hose Overview of vent systemsExamples are shown on the next Examples Dryer vent systems from metal piping ExampleConnecting directly to a wall Side view vent Vent collector duct Washer-dryer stack Technical data Programmable functions for changing Standard values Programmable functions Extending the range of drying levelsBuzzer normal default setting Buzzer loud Adjusting buzzer volumeFor programming and saving in memory, follow steps to Set memory function No Memory default settingMemory Extending cooldown time Default setting Change function of Filter/Vent indicationAdjust keypad tone No Keypad tone default setting Keypad tone onDefault setting Lower conductivity setting Changing water conductivity settingImportant condition Alteration rights reserved Nr 323 240