Miele T 4839 Ci operating instructions Other problems

	Problem solving guide
Other problems
Problem	Possible cause	Remedy
The drying	Please check all the possible causes and switch the dryer
process goes	off and then back on again.
on too long or	Ventilation to and from the dryer	Open a door or window while
even switches
	may be insufficient (e.g.	the machine is in operation for
off.
	because it is installed in a small	increased air flow.
In some	room). This has caused the
circumstances,	temperature in the room to rise
Clean out	sharply.
airways still	The fluff filters are clogged up	–	Remove any fluff.
appears, even
	with fluff or were still wet when	–	The fluff filters must be
though the
	they were replaced.		completely dry.
filters are
	The laundry has not been spun	Make sure that your laundry is
clean.
	sufficiently.	thoroughly spun at the
		appropriate spin speed.
	The tumble dryer has been	Do not exceed the maximum
	overloaded.	load for the programme
		selected.
	Metallic components, e.g. zips	– Open zips next time.
	have prevented the dryer from	If the problem occurs again,
	registering the correct moisture	dry garments with long zips
	level in the laundry.	using the Warm air
		programme (timed drying).
	Detergent residues, hair and	Check the condenser unit
	fine fibres can block up the	from time to time and clean it
	condenser unit.	if necessary.
	The vents below the door are	Remove any objects that are
	blocked.	blocking the vents.
The laundry is	The load consisted of different	– Finish drying using the
not sufficiently	fabrics.		Warm air programme.
dry.		–	Select a different
			programme next time.

35