Installation
Fitting a door front panel made by another manufacturer
Preparing the front panel
A Measure distance X for drilling the hinge holes.
– with spacer bars:
– without spacer bars:
(the front panel must be correspondingly higher)
B Mark the two hinge holes and the four smaller holes as shown in the diagram.
For left hand hinging only:
–front panel shown decor side face down, upper edge at the bottom:
if width (b) increases, measurement a must also be increased
b = 592 mm N a = 21.5 mm b = 593 mm N a = 22.0 mm b = 594 mm N a = 22.5 mm b = 595 mm N a = 23.0 mm b = 596 mm N a = 23.5 mm
H = height of adjacent furniture unit doors.
45