Miele T 4839 Ci operating instructions Preparing the fixing points

Installation

For right hand hinging only:

–front panel shown decor side face down, upper edge at the bottom:

if width (b) increases, measurement a must also be increased

b = 592 mm N a = 21.5 mm b = 593 mm N a = 22.0 mm b = 594 mm N a = 22.5 mm b = 595 mm N a = 23.0 mm b = 596 mm N a = 23.5 mm

H = height of adjacent furniture unit doors.

C Drill the two hinge holes (C 35 mm/15.5 mm deep) in the back of the front panel.

D Next, drill the four smaller holes

(C 7 mm/10 mm deep) in the back of the front panel.

E Shorten the front panel from the bottom to height H.

Preparing the fixing points

F Hold the pre-drilled front panel in the correct position in front of the machine door.

G Mark the fixing points on the back of the front panel through the holes in the machine door plate (see arrows in the illustration).

H Remove the front panel.

I Now drill holes (C 2.5 mm/10 mm deep) in the back of the front panel.

46