Whirlpool MFW 9700S, MFW 9600S manual Interlock Switch

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

DRIVE MOTOR INTERLOCK SWITCH

1

2

3

4

5

(Connector viewed From Wire End)

Refer to page 4-22 for the procedure for servic- ing the drive motor.

1.Unplug washer or disconnect power.

2.Disconnect the wire connector from the drive motor terminals.

3.Set the ohmmeter to the R x 1 scale.

4.Touch the ohmmeter test leads to the

following drive motor terminals. The meter should indicate between 3 and 8 Ω.

Terminals 1 & 2 Terminals 1 & 3 Terminals 2 & 3

Actuator

Refer to page 4-20 for the procedure for servic- ing an interlock switch.

1.Unplug washer or disconnect power.

2.Disconnect the wires from the interlock switch terminals.

3.Set the ohmmeter to the R X 1 scale.

4.Touch the ohmmeter test leads to the two interlock switch terminals. The meter

should indicate an open circuit with the actuator in, and a closed circuit (0 Ω) with the actuator out.

NOTE: Terminals 4 and 5 are for the tachom- eter.

5-6