Electrolux 137382100 A (1106) Electrical connection non-Canada 4 wire cord

Installation Instructions 13

Electrical connection (non-Canada) - 4 wire cord

4-wire receptacle

(NEMA type 14-30R)

WARNING

ELECTRICAL SHOCK HAZARD

Failure to disconnect power source before servicing could result in personal injury or even death.

1.	Turn off power supply to outlet.
2.	Remove the screw securing the terminal block
	access cover in the lower corner on the back of
	the dryer.
3.	Install a UL-approved strain relief according
	to the power cord/strain relief manufacturer’s
	instructions in the power cord entry hole below
	the access panel. At this time, the strain relief
	should be loosely in place.
4.	Thread an UNPLUGGED, UL-approved, 30
	amp. power cord, NEMA 14-30 type ST or
	SRDT, through the strain relief.
5.	Disconnect the internal (WHITE) dryer harness
	ground wire from the (GREEN) ground screw
	next to the terminal block.
6.	Attach the ground (GREEN) power cord wire
	to the cabinet with the ground (GREEN) screw.
	Tighten the screw securely.
7.	Move the internal dryer harness ground
	(WHITE) wire to the terminal block and attach
	it along with the neutral (WHITE) power cord
	wire conductor to the center, SILVER colored
	terminal on the terminal block. Tighten the
	screw securely.

		Neutral
30 AMP	Ground	(WHITE wire)
	(GREEN wire)
NEMA 14-30

Access cover

screw

Terminal

block

Line 2

(BRASS terminal)

Neutral

(SILVER terminal)

Line 1

(BRASS terminal)

Internal ground (GREEN screw)

Install

UL-approved

strain relief here

Terminal screw

recovery slot

NOTE

If a terminal screw falls during cord installation, it can be retrieved in the terminal screw recovery slot below the access panel.

8. Attach the RED and BLACK power cord

conductors to the outer, BRASS colored

terminals on the terminal block. Tighten both

screws securely.

WARNING

ELECTRICAL SHOCK HAZARD

Do not make a sharp bend or crimp wiring/ conductor at connections.

9.Follow manufacturer’s guidelines for firmly securing the strain relief and power cord.

10.Reinstall the terminal block cover.

Move internal ground (WHITE)

wire to neutral (SILVER)

terminal for 4-wire system.

GREEN

ground screw

GREEN

ground wire

Neutral

terminal

WHITE

neutral wire

BLACK or RED power wire

BLACK or

RED power wire