Start and Programmes
GB
Choosing a programme
1.Plug the dryer into the electrical socket.
2.Sort your laundry according to fabric type (see Laundry).
3.Open the door and make sure the filter is clean and in place and the water container is empty and in place (see Maintenance).
4.Load the machine and make sure items are not in the way of the door seal. Close the door.
5.If the On/Off light is not lit: Press the ON/OFF button 
.
6.Choose a programme by checking the Programmes Guide (see Programmes) as well as the indications for each type of fabric (see Laundry).
- Select a programme by rotating the PROGRAMMES knob.
7.Set a delay time and other options if necessary.
8.If you wish to select the buzzer sound, at the end of the programme, press the ALARM Option button.
9.Press the START button to begin.
During the drying programme, you can check on your laundry and take out items that are dry while others continue drying. When you close the door again, press the START button in order to resume drying.
10.During the last few minutes of Drying Programmes, before the programme is completed, the final COOL TUMBLE phase is entered (fabrics are cooled), this phase should always be allowed to complete.
11.When the programme is complete. The buzzer will sound if Alarm option was selected.
Open the door, take the laundry out, clean the filter and replace it. Empty the water container and replace it (see Maintenance).
If the Post Creasecare option has been selected and you do not remove the laundry immediately, the dryer will tumble occasionally for 10 hours or until you open the door.
12.Unplug the dryer.
Easy Iron Programme
‘Easy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The cycle relaxes the fibres and makes them easier to iron and fold.
!‘Easy Iron’ is not a drying programme and should not be used for wet articles of clothing.
For best results:
1.Do not load more than the maximum capacity. These numbers refer to the dry weight:
Fabric | Maximum load |
Cotton and Cotton mixtures | 2.5kg |
Synthetics | 2kg |
Denim | 2kg |
2.Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put them away in the closet. Should this not be possible repeat the programme.
The ‘Easy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton mix, and less well on acrylic fibres and on materials such as Tencel®.
4