Haier RDE/RDG 350AW user manual GAS Connections, GAS Dryer RDG350A

Page 16

English

4.Thread a U.L. approved 30 Amp power cord. NEMA 14-30 type ST or SRDT through the strain relief.

5.Attach the green power cord ground wire to the cabinet with green ground screw.

6.Attach the white (neutral) power cord conductors to the outer cord and the green ground wire from the dryer harness to the brass-colored center terminal on the terminal block. Tighten the screw securely.

7.Attach the red and black power cord conductors to the outer brass-colored terminals on the terminal block.

Warning: Do not make a sharp bend or crimp the wiring /conductor at connections.

8.Tighten the screws securing the cord restraint firmly against the power cord.

9.Tighten the strain relief nut securely so that the strain relief does not turn.

10.Reinstall the terminal block cover.­

GAS CONNECTIONS

GAS Dryer (RDG350A)

NOTE: DO NOT connect the dryer to L.P. gas service without converting the gas valve. An L.P. Conversion Kit must be installed by a qualified gas technician.

1.Remove the shipping cap from gas pipe at the rear of the dryer.

2.Connect a 1/2 inch (1.27cm) I.D. semi-rigid or approved pipe from gas supply line to the 3/8 inch (0.96cm) pipe located on the back of the dryer. Use a 1/2 inch to 3/8 inch (1.27cm to 0.96cm) reducer for a connection. Apply an approved thread sealer that is resistant to the corrosive action of liquified gases on all pipe connections.

3.Open the shutoff valve in the gas supply line.

4.Test all connections by brushing on a soapy water solution. NEVER TEST FOR GAS

LEAKS WITH AN OPEN FLAME.

5.Connect the exhaust duct to the outside exhaust system. Use duct tape to seal all joints.

6.With the dryer in its final position, adjust one or more of the legs until the dryer is resting solid on all four legs. Place a level on top of the dryer. THE DRYER MUST BE LEVEL

AND RESTING SOLID ON ALL FOUR LEGS.

7.Plug the power cord into a grounded outlet. NOTE: check to ensure power is OFF at circuit breaker/fuse box before plugging the power cord into the outlet.

8.Turn on the power at the circuit breaker/fuse box.

Before operating the dryer, make sure the dryer area is clean and free from combustible materials, gasoline, and other flammable vapors. Also see that nothing (such as boxes, clothing, etc.) obstructs the flow of combustion and ventilation air through the louvered panel located on the rear of the dryer.

9. Run the dryer through a cycle check for proper operation.

NOTE: On gas dryers, before the burner will light, it is necessary for the gas line to be bled of air. If the burner does not light within 45 seconds the first time the dryer is turned on, the safety switch will shut the burner off. If this happens, turn the dryer to “OFF” and wait 5 minutes before making another attempt to light.

NOTE: Follow instructons supplied with kit.

15

Image 16
Contents Model #/ Modéle #/ Para Modelo de # Table of Contents Important Safety Instructions Important Safety Instructions Save These Instructions Tools and materials required Installation InstructionsElectric Dryer RDE350AW Power Supply Cord Gas Dryer RDG350AWUnpacking Your Dryer Outlet ReceptacleExhaust Requirements Exhaust System RequirementsExplosion hazard Recommended Maximumm GAS Supply Requirements Installation in Alcove or Closet Do Not Install Your DryerLocation of Your Dryer Manufactured Mobile Home Installation Electrical Installation Wire Cord Connection US models only Electrical ConnectionsWire Cord Connections US Models Only GAS Connections GAS Dryer RDG350AConnecting the Dryer to the GAS Supply Replacement Parts All packing materials inaccessible to childrenOperating Instructions Temp ButtonCycle Select Dial Start/Pause ButtonPreparations Before Drying Load Clothes Into Dryer Auto DRY Cycle RDE/RDG 350AWTimed DRY Cycle Other Features Normal Operating Sounds Care and Cleaning GuideTips Troubleshooting Dryer makes noise when dryingDryer does not operate Dryer is working but not drying the clothesLimited Warranty Limited WarrantyTable des matières Instructions d’utilisation 44-50Intructions Importante DE Sécurité Instructions Importantes DE Sécurité Conservez CES Instructions Outils et matériaux requis Instructions D’INSTALLATIONSécheuse électrique RDE350AW Déballage de votre sécheuse Prise de courantExigences DU Système D’ÉCHAPPEMENT Risque d’explosionExigences du conduit d’échappement Exigences DE L’APPROVISIONNEMENT EN GAZ Avertissement’installez pas votre sécheuse ’EMPLACEMENT DE Votre SécheuseInstallation dans une alcôve ou un placard Installation Dans UNE Maison Préfabriquée Mobile Installation Électrique AvertissementBranchement Électrique Fil de mise à la terre Terminal de cuivre Branchement AU GAZ Sécheuse au gaz RDG350AWBranchement DE LA Sécheuse À L’APPROVISIONNEMENT EN GAZ PIèCES DE Remplacement Instructions D’UTILISATION Bouton TempCadran Cycle Select Bouton Start/PausePréparations Avant LE Séchage Remplissage DE LA Sécheuse Cycle DE Séchage Automatique Cycle DE Séchage À Minuterie Signal de fin de cycle Filtre à charpiePattes de mise à niveau Anti-froissementSons DE Fontionnement Normaux Guide D’ENTRETIENDépannage La sécheuse ne fonctionne pasLa sécheuse fonctionne mais ne sèche pas La sécheuse fait du bruit pendant le fonctionnementGarantie Limitée Garantie complète pendant UN anÍndice de Materias Garantía LimitadaImportantes Instrucciones DE Seguridad Importantes Instrucciones De seguridad Conserve Estas Instrucciones Peligro Instrucciones de instalación Herramientas y materiales necesariosSecadora eléctrica RDE350AW No se ofrece cuando la venta es dentro de EEUU. Debe serSecadora de Gas RDG350AW Desempacar su secadoraRecipiente Exterior Cable de alimentaciónRequisitos del sistema de escape de gas Requisitos del EscapeRigid Metal Flexible Metal No. of 90º Requisitos del suministro de gas No instale su secadora en Ubicación de su secadoraInstalación en hornacina o armario Instalación en hogares fabricados casas móviles Instalación Eléctrica Secadora Eléctrica RDE350AWConexiones eléctricas Terminal de latón Conexiones de gas Secadora de gas RDG350AConectar la secadora al suministro de gas Piezas DE Reemplazo Instrucciones DE USO Botón de temperaturaDial de Seleccionar Ciclo Botón para Empezar/PausarPreparaciones antes de secar Meta la ropa dentro de la secadora Ciclo DE AUTO-SECADO Ciclo DE Secado Temporizado Filtro de pelusas Patas niveladorasSeñal de fin de ciclo Anti-arrugasGuía de Cuidado y Limpieza Sonidos normales de operaciónConsejos Localización y resolución de problemas Si la secadora No operaAnda, pero no está secando la ropa Hace ruido mientras secaGarantía Limitada Do Not Return This Product To The Store Haier America New York, NY