A Title (English)
Cut Off Frequency Control
If the LPF/HPF select switch is set to LPF or HPF, you can select a cut off frequency from 40 Hz to 500 Hz.
ENGLISH
LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch
Set the LPF/HPF select switch as follows according to the type of speaker that is connected to the speaker output connector and the car stereo system:
LPF/HPF Select | Audio frequency range | Speaker | Remarks |
Switch | to be output | Type |
|
LPF (Left) | * — 40 Hz to 500 Hz | Subwoofer | Connect a subwoofer. |
|
|
|
|
OFF (Center) | Full range | Full range |
|
|
|
|
|
HPF (Right) | * 40 Hz to 500 Hz — | Full range | Use if you want to cut the |
|
|
| very low frequency range* |
|
|
| because it is not necessary |
|
|
| for the speakers you are |
|
|
| using. |
|
|
|
|
* See the “Cut Off Frequency Control” section.
Gain Control
If the sound level is too low, even when the volume of the car stereo used along with this power amplifier is turned up, turn gain control clockwise. If the sound distorts when the vol- ume is turned up, turn the gain control
•When using with an RCA equipped car stereo (standard output of 500 mV), set to the NORMAL position. When using with an RCA equipped Pioneer car stereo with max. output of 4 V or more, adjust level to match the car stereo output level.
•If you hear too much noise when using the speaker input terminals, turn the gain control
Input Switch
It is possible to input from a car stereo external output (subwoofer output) or a car stereo speaker output. When using an external output (subwoofer output), slide the switch to the left. For connection instructions, see the “Connection Diagram” section. When using a speaker output, slide the switch to the right. In this case, it is necessary to use the supplied speaker input wire with RCA pin cord. For details, see the “Using the Speaker Input” sec- tion.
ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS êìëëäàâ
67