| Section |
Operating this unit | 02 |
|
|
Tuner
Listening to the radio
1Press SOURCE to select the tuner.
2Press BAND to select a band.
Press BAND until the desired band (F1, F2 for FM or MW/LW) is displayed.
3Press c or d to set the sensitivity. FM: LOCAL
LOCAL 4
MW/LW: LOCAL 1—LOCAL 2
The LOCAL 4 setting allows reception of only the strongest stations, while lower settings let you receive progressively weaker stations.
English
3To perform manual tuning, briefly press c or d.
4To perform seek tuning, press and hold c or d for about one second and release. The tuner will scan the frequencies until a broadcast strong enough for good reception is
found.
# You can cancel seek tuning by briefly pressing
c or d.
# If you press and hold c or d you can skip sta- tions. Seek tuning starts as soon as you release the button.
Storing and recalling broadcast frequencies
%When you find a frequency that you want to store in memory, press one of pre- set tuning buttons 1 to 6 and hold until the preset number stops flashing.
Memorized radio station frequency can be re-
called by pressing the preset tuning button.
# Up to 12 FM stations, 6 for each of the two FM bands, and 6 MW/LW stations can be stored in
memory.
# Press a or b to recall radio station frequen- cies.
Tuning in strong signals
Local seek tuning lets you tune in only those radio stations with sufficiently strong signals for good reception.
1Press FUNCTION to select LOCAL.
2Press a or b to turn local seek tuning on or off.
Storing the strongest broadcast frequencies
BSM (best stations memory) lets you automa- tically store the six strongest broadcast fre- quencies under preset tuning buttons 1 to 6. Once stored you can tune in to those frequen- cies with the touch of button.
!Storing broadcast frequencies with BSM may replace broadcast frequencies you have saved using buttons 1 to 6.
1Press FUNCTION to select BSM.
2Press a to turn BSM on.
Six strongest broadcast frequencies will be stored in the order of their signal strength.
#To cancel the storage process, press b.
Switching the RDS display
RDS (radio data system) contains inaudible in- formations that helps searching of the radio stations.
!RDS service may not be provided by all sta- tions.
!RDS functions such as AF and TA are only active when your radio is tuned to an RDS station.
%Press DISPLAY.
Press DISPLAY repeatedly to switch between the following settings:
Program service
#PTY information and the frequency appear on the display for eight seconds.
En | 7 |