Dynacord PowerMate 600 owner manual Specifications

Page 61

SPECIFICATIONS

Technical Specifications PowerMate600 Mixing desk in rated condition, Unity Gain (MIC Gain 20 dB), all faders position 0 dB,

all pots in mid position, master fader + 6dB, amplifier rated output power into 8 Ohms, dual channel, unless otherwise specified.

Maximum Midband Output Power, 1 kHz, THD=1%, Dual Channel

into 4 Ohms into 8 Ohms

Rated Output Power, THD=0.1%, Single Channel into 4 Ohms

into 8 Ohms

Maximum Midband Output Power, 1 kHz, THD=1%, Single Channel into 4 Ohms

into 8 Ohms

Maximum Output Voltage of power amplifier, no load THD at 1kHz, MBW=80kHz

MIC input to Main L/R output, +16 dBu, typical Power amplifier input to Speaker L/R output DIM 30, power amplifier

IMD-SMPTE, power amplifier, 60Hz, 7 kHz Frequency Response, -3dB ref. 1kHz Any input to any Mixer output

Any input to Speaker L/R output Crosstalk, 1kHz

Fader and AUX-Send attenuation Channel to channel

CMRR, MIC input, 1kHz

Input Sensitivity, all level controls in max. position MIC input

LINE Input (Mono)

LINE Input (Stereo)

Power Amplifier Input Maximum Level, mixing desk MIC inputs

Mono Line inputs Stereo Line inputs All other inputs Record Send output All other outputs

Input Impedances

MIC

Insert Return

EQ Input and 2 Track Return

All other inputs

Output Impedances

Record Send Phones

All other outputs

Equivalent Input Noise, MIC Input, A-weighted, 150 Ohms Noise, Channel inputs to Main L/R outputs, A-weighted Master fader down

Master fader 0 dB, Channel fader down

Master fader 0 dB, Channel fader 0 dB, Channel gain unity Signal/Noise-Ratio,power amplifier, A-weighted

Equalization

LO Shelving

MID Peaking, mono inputs MID Peaking, stereo inputs HI Shelving

Master EQ, 2x7-band, 63, 125, 400, 1k, 2k5, 6k, 12k Hz Power Consumption at 1/8 maximum output power, 4 Ohms Dimensions, (WxHxD), mm

Weight, without lid

Optional

RMK-600 (Rack-Mount-Kit PowerMate600)

Gooseneck Lamp, 12V/2.4W, 12“, XLR

FS11 (Footswitch)

2 x 270 W

2 x 180 W

2 x 300 W

2 x 150 W

2 x 340 W

2 x 200 W

43Vrms

<0.006%

<0.08%

<0.03% < 0.2%

15Hz ... 60kHz 30Hz ... 40kHz

>80 dB

>70 dB

>80 dB

-74 dBu (155 μV) -54 dBu (1.55 mV) -34 dBu (15.5 mV)

+6 dBu (1.55 V)

+11 dBu

+30 dBu

+20 dBu

+20 dBu

+14 dBu

+20 dBu

1.8kOhms

10 kOhms

15 kOhms

>15 kOhms

1 kOhm

47Ohms

75Ohms -130 dBu

-90 dBu -89 dBu -83 dBu

105dB

±15 dB / 60 Hz

±15 dB / 2.4 kHz

±15 dB / 2.4 kHz

±15 dB / 12 kHz

±10 dB

450 W

461.5x 176.5 x 366.5 13kg

112741

112700

110693

61

Image 61
Contents PowerMate Inhalt ContentsTable DES Matières Wichtige Sicherheitshinweise Auspacken und Garantie BeschreibungAufstellen und Anschließen MIC Input MonoLine Einstellhinweis GainKlangregelung Volume Signal / PEAK- AnzeigeAUX PANStereo Input L / Mono R Input StereoLine Trim 13. FX Signal / PeakBAL Umstellung der Effekt-Startprogramme FX1/FX2FX1/FX2 DisplayFX on 19. UP/DOWNPeak LED EinstellhinweiseAUX/MONO Effekt 1/2 Status Anzeige MasterBand Stereo Graphic Equalizer Master L + R Master LED-DISPLAYRückseite PowerSpeaker Outputs Right / Left Unsymmetrisch Aufbau Einer STANDARD-PASymmetrisch Unsymmetrisch SymmetrischAufbau Soundcheck Monitormix OWNER‘S Manual Contents Important Safety Instructions Description Installation and ConnectionsInput Mono EQ Section Signal / Peak indicator Tone Control Section Stereo Input L/MONO R13. FX AUX BAL SIGNAL/PEAKChanging FX Start Programs 19 . UP/DOWN Setting InstructionsGenerally, the AUX channel is used as monitor bus Phones Effect 1/2Status Indicator Master LED-DISPLAY Rear Panel Cabling STANDARD-PASpeaker Cables LF-CABLES Balanced or UNBALANCED?Setting up Main MIX Sound CheckMonitor MIX Mode D‘EMPLOI Table DES Matières Instructions DE Sécurité Importantes Introduction Installation et BranchementsDynacord Déballage et garantieLine Ligne Entrée MonoSection EQ Égaliseur Conseils de réglageFX Effets Indicateur SIGNAL/PEAKSection DE Contrôle DU SON Tone Entrée StereoSIGNAL/PEAK Changer les effets de démarrage Lire le paragraphe «Changer les effets de démarrage»Temoin Peak AfficheurInstructions de réglage Effect Return Retour D’EFFETMaster Phones Sortie casques Power AMP Inputs Entrées AmplificateurTrack Return L/R Retour 2 Pistes Track Return39. Égaliseur Graphique Stéréo 7 Bandes 38. Témoins Indicateurs D‘ÉTATMaster L+R 40. Échelle DE LED MasterSpeaker Outputs RIGHT/LEFT Sorties HP gauche/ droite Panneau ArrièreCâblage Installation D‘UN Système DE Sonorisation StandardCâbles de haut-parleur Câbles basse fréquence Symétrisés ou non symétrisés ?Installation Mixage Principal Sound CheckMixage DU Circuit Moniteur Specifications Block Diagram Dimensions Bosch Communications Systems
Related manuals
Manual 64 pages 54.56 Kb