Peavey PV 20 manual Power Switch, Removable Power Cord, USB port and USB Record Level Control

Page 13

Rear Panel

DANS LE BUT DE REDUIRE LES RISQUES D’INCENDIE OU DE DECHARGE

POWER

 

ON

 

100 - 240V

50/60Hz

27 WATTS

42 43

INPUT

BALANCED

 

 

TRS INSERT

1 - GROUND

T (POS)

SLEEVE

2 - POSITIVE

R(NEG)

 

 

TIP

3 - NEGATIVE

S (GND)

 

 

RING

OUTPUT

UNBALANCED

 

 

TIP = SND

1 - GROUND

T (POS)

 

 

2 - POSITIVE

 

 

 

RING = RET

3 - NEGATIVE

S (GND)

 

 

SLEEVE = GND

peavey.com

 

DIGITAL AUDIO

A PRODUCT OF

PORT

PEAVEY ELECTRONICS CORP.

 

 

 

DESIGNED IN USA MADE IN CHINA

 

 

 

 

 

 

 

COMPUTER

MIN

 

RECORD

 

LEVEL

42Power Switch

Depressing the power switch supplies power to the unit.

Warning: The power switch in this unit breaks only one side of the line. Hazardous energy may be present inside the mixer when the power switch is in the OFF position.

43Removable Power Cord

This receptacle is for the IEC line cord (included) that provides AC power to the unit. Connect the line cord to this connector and to a properly grounded AC supply. Damage to the equipment may occur if an improper line voltage is used (see voltage marking on unit). Never remove or cut the ground pin of the line cord plug. The console is supplied with a properly rated line cord. If lost or damaged, replace this cord with one of the proper rating.

NOTE FOR UK ONLY:

If the colors of the wires in the mains lead of this unit do not correspond with the colored markings iden- tifying terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be connected to the terminal marked by the letter E, or by the earth symbol, or colored green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter N, or colored black. (3) The wire that is colored brown must be connected to the terminal that is marked with the letter L or colored red.

44USB port and USB Record Level Control

The USB port is used to connect the PV™ Series USB mixer to acomputer for recording or playing back digital audio to/from your computer. The USB port sends the mixer’s main/tape stereo out to the computer. The amount of the main mix signal being sent to the USB port can be adjusted using the Record Level control located next to the USB port. The USB port receives digital audio from the computer; it can then be assigned through the “Tape/USB to Mix” switch (27) to the main left/right output. The USB input level is controlled by the computer volume control.

Compatible with Windows® XP, ME & 2000. Also compatible with Mac OS X® 10.0 or later.

INPUT

BALANCED

 

 

 

TRS INSERT

1 - GROUND

 

T (POS)

SLEEVE

2 - POSITIVE

 

R(NEG)

 

 

 

 

 

 

TIP

3 - NEGATIVE

 

S (GND)

 

 

 

 

 

 

RING

OUTPUT

UNBALANCED

 

 

 

TIP = SND

 

 

 

1 - GROUND

 

T (POS)

 

 

 

 

 

 

 

RING = RET

2 - POSITIVE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SLEEVE = GND

3 - NEGATIVE

 

S (GND)

 

 

 

 

 

 

 

 

 

 

 

 

DIGITAL AUDIO

 

 

 

 

 

 

 

 

PORT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

COMPUTER

 

MIN

 

 

 

RECORD

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

LEVEL

 

 

 

 

 

 

 

 

 

 

 

 

44

13

Image 13
Contents PV10 PV14 PV20 Page Important Safety Instructions Bewahren SIE Diese Sicherheitshinweise AUF Gardez CES Instructions Guarde Estas Instrucciones Compact Mixers EnglishHz Low Cut Front PanelHi EQ Mid EQFader Signal LEDTape In/Out EFX SelectPower LED Green Signal LED and Red Clip LEDPhantom Power LED EFX TimeRear Panel Insert 36 A/B SwitchStereo 1⁄4 Inputs RCA InputsRemovable Power Cord Power SwitchUSB port and USB Record Level Control Diagram Levels Function Min Load Bal Connector Bal ConnectorInputs Function Input ZCommon Mode Rejection Ratio Mic Input PV10, PV14, & PV20 Specifications Frequency ResponseMeters Signal/Overload Indicators WeightCaracterísticas EspañolPanel Frontal LED de señal LED de Saturación/MuteadoDeslizador Entrada/Salida de CintaLED verde de señal y LED rojo de saturación Tiempo de EfectoRetorno de efectos Control general del Envío de MonitoresRear Trasero Entradas Estéreo 1/4 InserciónEntradas RCA Conmutador A/BCable de Alimentación Extraíble Conmutador de Alimentación Power SwitchPuerto USB y Control de grabación USB Diagram-PV10, PV14 Min Nominal Función Input ZGanancia Distorsión Armónica Total PV10, PV14, & PV20 Especificaciones Respuesta en FrecuenciaSalida Condiciones de testConsole de Mixage Compacte CaractéristiquesMON Send Panneau avantPV20 L Ce contrôle vous permet d’ajuster l’effet sélectionné Tape to Mix Tape/USB to Mix Panneau arrièreTape/USB to Main PV 20 seulement Line 1⁄4 Inputs Port USB/USB Record Level Control Modifiés PréavisSans Caractéristiques et spécifications peuvent êtreRéglage Bal Connecteur Niveaux d’entrées FonctionSorties De sorties Fonction Charge Bal ConnecteurDistortion Harmonique Totale Specifications PV10, PV14, & PV20 Reponse en FréquencesSortie Bruit résiduel Conditions TestMerkmale Kompakt-Mischpult BeschreibungHz-Tiefpass VorderseiteEFX Send PanClip/Mute-LED Signal-LEDTape In/Out EFX-AuswahlPower-LED 17 Grüne Signal-LED und rote Clip-LEDHeadphone-Pegel LED-MessanzeigenRückseite Cinch-Eingänge Stereo-Eingänge 6,3 mm36 A/B-Schalter Control-Room-AusgängeAbziehbares Netzkabel Power-SchalterUSB Port und USB Port Level Control Line EFX Time Adjust Selector Sym Stecker EingängeAusgänge Ausgangspegel Funktion Min. Last Sym/Un Stecker PV10, PV14, & PV20 Technische Daten Frequenzverhalten Signal-/ÜberlastanzeigenNichtlineare Gesamtverzerrung Ausgang RestrauschenPeavey Electronics Corporation Limited Warranty EX000030