Peavey Understanding PV14 Watts and Specifications for Mixing Consoles

PV™10, PV™14, & PV™20 Specifications

Frequency Response

Mic Input to Left/Right Output

14 Hz to 25 kHz +0 dB/-1 dB

Total Harmonic Distortion

<0.02% 20 Hz to 20 kHz Mic to Left/Right Output	(10 Hz to 80 kHz BW)
<0.005% Typical	(22 Hz to 22 kHz BW)
<0.0007% Mic Pre-amp Distortion

Hum and Noise
		Output	Residual Noise	S/N Ratio (Ref: +4dBu)		Test Conditions
		Master Left/Right	-97 dBu	101 dB		Master Fader Down, Channel Levels Down
			-90 dBu	94 dB		Master Fader Nominal, Channel Levels Down
			-83 dBu	87 dB		Master Fade Nominal, Channel Faders Nominal,
						Panned Odd Channels (left), Even Channels (right)
		Monitor Send	-95 dBu	99 dB		All controls off
			-80 dBu	84 dB		All channel sends nominal, masters nominal
		Effects Sends	-100 dBu	104 dB		All controls off
			-80 dBu	84 dB		All channel sends nominal, masters nominal
	(Hum and noise measurements: 22 Hz to 22 kHz BW)
Equivalent Input Noise (EIN)
		-129 dBu (input terminated with 150 ohms)
Crosstalk/Attenuation
		Adjacent Input Channels (1 kHz) >90 dB			Mute Button Attenuation (1 kHz) >90 dB
		Left to Right Outputs (1 kHz) >75 dB			Channel Fader Kill (1 kHz) >85 dB

Common Mode Rejection Ratio (Mic Input)

50 dB minimum (20 Hz to 20 kHz)

70 dB typical @ 1 kHz

Meters	Signal/Overload Indicators
8 segment, peak reading (0 db = +4 dBu)	Red LED lights 3 dB below clipping
Dimensions
PV10: 12.125" wide x 14.75" deep x 3.5" high	PV20: 22.125" wide x 15.75" deep 3.5" high
(30.80cm x 37.47cm x 8.89cm)	(56.2cm x 40.0cm x 8.9xm)

PV14: 16.125" wide x 14.75" deep x 3.5" high (40.96cm x 37.47cm x 8.89cm)

Installation Note:

This unit must have the following clearances from any combustible surface: top: 8", sides: 12", back: 12"

Weight		Power Requirements
PV10:	9.3 lbs. (4.22 kg)	PV10: 100-240 VAC 50/60 Hz 13 Watts
PV14:	12.1 lbs (5.49kg)	PV14: 100-240 VAC 50/60 Hz 17 Watts
PV20: 16.3 lbs. (7.39kg)		PV20: 100-240 VAC 50/60 Hz 27 Watts

16