Peavey PV 20 EFX Time, Green Signal LED and Red Clip LED, EFX Return, MON Send Master, LED Meters

Front Panel

16EFX Time

This control adjusts the time of the particular reverb or delay.

17Green Signal LED and Red Clip LED

The green Signal LED and red Clip LED are used to set the operating input level to the PV™10, PV™14, and PV™20 effects processors. The signal level to the processor is affected by channel Fader, the Effects Send and the Effects Send Master Controls. Start with the Master Control (20) set to 0 (12 o’clock) and adjust the channel sends so that the signal LED lights and the clip LED blinks on occasionally, if at all. The clip LED lights 6 dB below clipping. Pressing the EFX defeat mutes the effects signal and lights the clip/mute LED.

18EFX Return

Once the input level is set (see 17) use the EFX Return control to mix the effects processor output into the main left/right outputs. Remember, a little reverb goes a long way.

19MON Send Master

This is the master output level control for the monitor mix. The output level sent to the Monitor Send jack (37) is con- trolled by the channel Monitor Send controls (6) and by this master control.

20EFX Send Master

This is the master output level control for the EFX mix. The output level sent to the EFX Send jack and the internal ef- fects processor is controlled by the channel Fader (12), the channel EFX Send controls (7), and by this master control. The 0 position is the recommended setting for this control.

19

20

23

24

25

3	0	3	MON1
6			SEND

155

40

10dB

3	0	3	MON2
6			SEND

155

40

10dB

0EFX

6 33 SEND

155

40 10dB

POWER

+48V

PHANTOM

3	0	3	HEADPHONE
6
15			5
40		10dB
4	5	6		TAPE/USB
3		7		TO MAIN
2			8
1 0		10 9

LR

CLIP

+6

0

-3

-6

-12 -20

-30

21

28

22

21	Headphone Level						MASTER LEVEL
	This knob sets the headphone and control room output						10
				CTRL/HP
			TAPE/USB TO
	levels. To avoid damage to your hearing‚ make sure to turn	26					6
	the dial fully counterclockwise before using headphones.					TO MIX
		27		TAPE/USB
	Slowly turn the knob clockwise until you reach a comfort-						0
							6
	able listening level. Normally, the signal in the headphones	29		CONTOUR
	is the left/right signal. If the Tape to Control Room (26) is						12
	engaged‚ the tape signal is also included.						20
		30			USB
	LED Meters			EQUIPPED
22
	Two eight-segment LED arrays are provided to monitor the
	levels of the main left/right outputs. These meters range
	from -30 dB to +19 dB. The 0 dB position on the meter corresponds to +4 dBu at the outputs.

MASTER

23Power LED

This LED indicates AC power is supplied to the unit‚ the power switch is on, and the unit is functioning properly.

24Phantom Power LED

This LED lights when the Phantom Power Switch (25) has been engaged.

10