INSTALLATION
8)Secure with 2 Phillips Head Screws as shown. See Diagram 6 inset
12)Partially mount the heat shield to the left side of the faceplace and connect the CAT5 cable to the ECS manual control switch. See diagram 9.
Diagram 6
Faceplate
Diagram 7
9)Bring faceplate close to unit.
10) Run thermodisc wires from top of heat defl ector through left side of faceplate. See Diagram 7.
11)Place the cable ties thru the cable tie holders in the heat shield loosely to secure loose wires.
Run the CAT5 cable from the unit thru the cable ties on the heat shield and tighten cable ties. Ensure not to overtighten. Cut excess cable tie. See diagram 8.
CAT5 Cable
Diagram 8
Diagram 9
13)Secure the heat shield to the faceplate using 2 screws. See diagram 10. NOTE: Screws are secured from the front.
Diagram 10
Regency IG35 Gas Inbuilt Fireplace | 17 |