Regency IG35-NG, IG35-LPG Maintenance Instructions, Door Glass Replacement, LOG Replacement

MAINTENANCE

MAINTENANCE

INSTRUCTIONS

Any maintenance required accessing the glass door of the unit must be performed by an authorized service person.

1) Always unplug the power cord before

cleaning. For relighting, refer to lighting

instructions. Keep the burner and control

compartment clean by brushing and vacu-

uming at least once a year. When cleaning

the logs, use a soft clean brush as the logs

are fragile and easily damaged.

2) Clean glass (never when unit is hot), appli-

ance, louvres, and door with a damp cloth.

Never use an abrasive cleaner. The gold

louvres (and optional gold door) may be

scratched if abrasives are used to clean

them.

The heater is finished in a heat resistant

paint and should only be refinished with

heat resistant paint (not with wall paint).

Regency uses StoveBright Paint - Metallic

Black #6309.

CAUTION: ANY SAFETY SCREEN ORGUARDREMOVEDFORSERV- ICING AN APPLIANCE MUST BE REPLACED PRIOR TO OPERAT- ING THE APPLIANCE.

CLOTHING OR OTHER FLAM- MABLE MATERIAL SHOULD NOT BE PLACED ON OR NEAR THE APPLIANCE.

DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. IMMEDIATELY CALL AN AUTHORIZED SERVICE TECHNI CIAN TO INSPECT THE APPLI- ANCE AND TO REPLACE ANY PART OF CONTROLSYSTEMAND ANY GAS CONTROL WHICH HAS BEEN UNDER WATER.

6)Verify proper operation after servicing.

DOOR GLASS

REPLACEMENT

Your Regency stove is supplied with high tem- perature, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass by impact, purchase your replacement from an authorised Regency dealer only, and follow our step-by-step instructions for replacement.

WARNING: do not operate appli- ance with the glass front removed, cracked or broken. Replacement of the glass should be done by a licensed or authorised service person.

Flush Glass Replacement

Slide old glass out of the side frames and replace with new glass.

3) Make a periodic check of burner for proper

position and condition. Visually check the

flame of the burner periodically, making sure

the flames are steady; not lifting or floating.

If there is a problem, call an authorized

service person.

4) The appliance and flueing system must be

inspected before use, and at least annu-

ally, by an authorized field service person,

to ensure that the flow of combustion and

ventilation air is not obstructed.

During the annual service call, the burners

should be removed from the burner tray

and cleaned. Replace the embers - do not

block the burner ports.

5) Keep the area near the appliance clear and

free from combustible materials, gasoline

and other flammable vapours and liquids.

WARNING: CHILDREN AND ADULTS SHOULD BE ALERTED TO THE HAZARDS OF HIGH SURFACE TEMPERATURE AND SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING IGNITION. YOUNG CHILDREN SHOULD BE CAREFULLYSUPERVISED WHEN THEY ARE IN THE SAME ROOM AS THE APPLIANCE.

LOG REPLACEMENT

The unit should never be used with broken logs. Unplug the power cord and allow the unit to cool before opening door to carefully remove the logs. If for any reason a log should need replacement, you must use the proper replacement log. The position of these logs must be as shown in the diagram under Log Installation.

Note: Improper positioning of logs may create carbon build-up and will alter the unit’s performance which is not covered under warranty.

GLASS GASKET

If the glass gasket requires replacement use 7/8" flat glass gasket (Part # 936-243).

Regency IG35 Gas Inbuilt Fireplace 25