INSTALLATION
FACEPLATE,
TRIM & LOUVER
INSTALLATION
1)Lay the faceplate panels flat, face down on something soft so they don't scratch.
2)Take the top faceplate and align the holes in it with the holes in the side panels. Us- ing the screws provided, attach from the top of the panel (the holes in the top panel are slightly larger than the holes in the side panel to facilitate easier installation).
4)Connect the fan harness to the fan switch.
5)Connect the valve harness to the valve on/off switch.
6)Tuck the wires into the faceplate to keep them away from the inbuilt fireplace using the clip provided. Attach the clip to the rear of the faceplate to ensure that the wires do not touch the side of the unit.
7)The power cord should be run behind the faceplate panel.
10)Push the Regency logo plate into the two holes in the bottom left corner of the face- plate.
11)Place the 2 hinges for the bottom louver in position and secure using 4 screws per hinge.
12)Place the bottom louver in position and secure it with 6 screws.
8) Place the trim on the assembled faceplate | 13) Install the safety screen by inserting the 4 |
panels and secure it with the side screws. | screen brackets into the 4 slots. |
Diagram 1
Hint: Don't tighten the trim to the bottom of the faceplate side panels with the screws provided. See diagram 1.
3)Using the connectors provided, join the left side trim to the top trim. Connect the right side trim to the top trim.
Screen
Bracket
Slots
| 14) Install the top louver by sliding the 2 bracket |
9) Attach the faceplate panels* to the inbuilt | clips into the brackets located on top of the |
fireplace body using 4 black screws. | unit. |
Diagram 2 | Side | |
Rear View: Trim Assembly | ||
Screws | ||
|
Regency IG35 Gas Inbuilt Fireplace | 15 |