INSTALLATION
Conversion Kit #486-968 for NG to LPG Model
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
Conversion Kit
Qty. Part # Description
1
1
1
1
1)Shut off the gas supply and unplug the power cord.
2)Remove the front door.
3)Remove logs.
4)Remove the rear log tray by removing the 2 screws. (Log tray must be rotated to clear the burner.)
7)Remove burner orifice with a 1/2" wrench and discard. Use a wrench to hold on to the elbow behind the orifice.
8)Reinstall new burner orifice LPG stamped #51 and tighten.
9)Stick the conversion label "This unit has been converted to LPG" over top of the serial number decal.
10)Replace the yellow "NG" label with the red "LPG" label.
11)Carefully pull out the control box.
NOTE: The control box is held in place with velcro.
12)Remove the heat shield from the control box by removing the 2 screws.
13)Remove the control box cover by undoing the 3 screws. Maneuver through antenna.
Antenna
Control Box
Cover
14)Remove the jumper using a plier.
5)Remove the grate.
6)Remove the burner and adjust the aeration setting to 15 mm fully open.
Jumper Location
Jumper
Heat Shield
15)Reverse steps 13, 12, 11, 6, 5, 4, 3 & 2.
Regency IG35 Gas Inbuilt Fireplace | 9 |