INSTALLATION
19)Carefully lift off the ignition module from the velcro and slightly bring forward. Remove the wire harness connected to the ignition module as shown in diagram 17.
22)Connect the other end of the new wire harness to the valve, in place of the one removed in step 16. See diagram 20.
Wire Harness
Removed
Diagram 17 | Ignition |
|
| Module | Diagram 20 |
|
|
20)Discard the complete wire harness that was connected to the valve and ignition module.
21)Take the wire harness included with the kit and connect one end of the wire harness to the ignition module (in place of the one removed), see diagram 18 .
Place the ignition module back on the velcro at the base of the fi rebox. Ensure to run the loose wires from the wire harness in behind the bracket on the left side of the ignition module. See diagram 19.
Diagram 18
23)Disconnect the red split wires from the wire harness as shown in diagram 21.
Diagram 21
24)Feed the remaining thermodisc wires thru the opening on the bottom of the left side of the fi rebox and run them in behind the bracket to the left of the valve. See diagram 22.
Connect the 2 wires from the thermodisc to the appropriate wire on the harness; female to male, male to female.
| Bracket | Diagram 22 | |
Diagram 19 | Bracket |
|
|
|
|
| |
|
|
|
|
Regency IG35 Gas Inbuilt Fireplace |
| 19 |