INSTALLATION
REMOTE CONTROL
Use the Regency Remote Control Kit approved for this unit. Use of other systems may void your warranty.
The remote control kit comes with a hand held transmitter and a wall mounting plate.
1)Choose a convenient location to mount the hand held transmitter, protection from extreme heat is very important.
By usiing the wall mounting plate to house the transmitter, the remote can also be used as a wall thermostat.
FINAL CHECK
Before leaving this unit with the customer, the installer must ensure that the appliance is firing correctly. This includes:
1)Clocking the appliance to ensure the cor- rect firing rate (rate noted on label) at 15 minutes.
2)If required, adjusting the primary air to ensure that the flame does not carbon. First allow the unit to burn for 15 min. to stabilize.
3)Check for proper draft.
CAUTION
Any alteration to the product that causes sooting or carboning that results in damage to the exterior facia is not the responsibility of the
Caution: Ensure that the wires do not touch any hot surfaces and are away from sharp edges.
WIRING
This unit is polarity sensitive and will not operate if polarity is incorrect.
STANDARD WIRING
Regency IG35 Gas Inbuilt Fireplace | 21 |