Cal Flame G3000 owner manual Canopy Waterfall and Barbecue Island Waterfall, LED Lights

Operating Your Barbecue

Canopy Waterfall and Barbecue Island Waterfall

Although the canopy waterfall and the barbecue island waterfall have different appearances and locations, they operation in the same manner.

•Fill the tank with water and make sure the water level is above the submersible pump.

•Ensure the pump is connected to 110V GFCI outlet.

•M ake sure that there is no debris in the filler pan for the waterfall.

•Maintain a consistent water level, as dry pumping will burn out the pump motor.

•Turn on the waterfall by flipping up the switch to the ON position (Figure 47).

Figure 47

LED Lights

LED lights use an ON/OFF switch to change one show to the next. (See Figure 45.)

•Turn OFF and then ON again in one second or less to go to the next show.

•Turn OFF and then ON again in four to five seconds to reset to the first show.

•Turn OFF for more than six seconds and it stores the last show you selected, returning to that show the next time it is switched ON.

Note: When the LED lights are powered ON check that all LED lights are synchronized. If not turn the switch ON and OFF fast several times and then hold the switch OFF for six seconds and then turn ON to get all the LED lights synchronized.

Slow color wash	Colors transition gracefully from color to color, cycling trough the
	color spectrum. Each color cycle takes approximately three minutes.
Fast color wash	Colors transition from color to color, cycling through the color spec-
	trum. Each color cycle takes approximately one minute.
Slow Random color	Colors step or jump from one color to the next in random order.
	Each color lasts approximately 10-15 seconds
Fast Random color	Colors step or jump from one color to the next in random order.
	Each color lasts approximately five seconds.
Barbecue Owner’s Manual	Page 39

12/17/04 www.calspas.com