Cal Flame G3000 owner manual Remote Control Operation

Operating the Cal Flame Entertainment Center

Remote Control Operation

Eject/ DVD

TV/DVD

Auto Program

Skip/Search

Erase/Add

Channel Up

Menu

Enter

Return Channel Down

Vol -

TV

Program

SubTitle

Stop

Pause/Replay

NEXT

PREV

TV/CATV

Power

Channel Pad

PRC/Sel

Mute

Display

Vol +

DVD

VCR

Angle

Audio

Play

REW

FF

TV Power

Press this button to turn on the set.

Press the button again to turn the set off.

Direct Access (0-9, 1--) Number Buttons

Use these buttons to select a channel. The channel number chosen will be displayed on the screen for about four seconds. To select channels 0-99, press two numbers. For example, to select channel 8, press 0,8. To select above 100, press the 1-button, then the number buttons for the last two digits of the channel. For example, to select channel 115, press 1--, 1,5.

CHANNEL Up and Down

Use these buttons to select pre-programmed channels of two select channels up or down.

VOLUME Up and Down

Use these buttons to raise or lower the volume level of the Wired Headphones or External Speakers if installed. They are also used to make adjustments in the picture mode.

Figure 49. Remote control

NOTE: These buttons will not affect the volume of wireless headphones or a wired RF modulator. When using these devices, the volume must be adjusted with the headphone volume control or with your radios volume control.

MENU Button

Press the MENU button. The MENU display appears. Use the Channel Up and Down buttons to select the desired function, then press ENTER button to end the choice.

TV/VIDEO Button

Press this button to access the AUDIO/VIDEO input jacks, on the front and rear of the TV. As the but- ton is pressed, the on-screen display will cycle as follows:

TV AV1 AV2 AUX

MUTE Button

Press this button to turn the TV sound off. Press again to restore sound to the previously set level. MUTE may also be released by pressing the VOLUME +/-.

Page 42 Barbecue Owner’s Manual

www.calspas.com 12/17/04