Pelco C1300M-C (11/08) manual C1300M-C 11/08

Page 10

10

C1300M-C (11/08)

Image 10
Contents ExSite Series Explosionproof Positioning System Page Contents Specifications Regulatory Notices Radio and Television InterferenceModels Configure DoneWelcome Getting StartedHow to Operate Your System KBD200A/KBD300A Direct Mode only Accessing Main Menu PresetKBD4000/KBD4002 Genex Multiplexer Quick Start Guide System Setup C1300M-C 11/08 Language OFF default Use for normal installations refer to Figure Unit InversionSystem Information Display Setup Label Positions Unit Settings CameraIR CUT Filter 23X DAY/NIGHT Camera DarkShutter Speed Advanced Camera SettingsAGC Limit Auto White Balance Auto IrisAuto Sharpness GainWide Dynamic Range 23X DAY/NIGHT Camera Backlight Compensation BLCVideo Level NormalProportional PAN There are two proportional pan modes On defaultMotion Amount of zoomPark Time Scan Speed Preset Freeze FrameThere are three preset freeze frame settings Image is never frozenScan Limit StopsManual Limit stop is reachedAzimuth Zero Power UP Action Power UPNone Line Sync Phase settings range from 0-359 degreesSystem synchronizes to an internal clock Presets Enable Motion Detection 23X DAY/NIGHT Camera Edit Detection Areas 23X DAY/NIGHT CameraTriggers a command to AUX Activate AUX Command 23X DAY/NIGHT CameraAUX Time 23X DAY/NIGHT Camera Patterns Zones Window Blanking To set a window blanking areaClear Window Available OFF default No blankingReverse Blank ALL ABOVE/BLANK ALL belowResume AlarmsReset Delay SequenceMEDIUM/LOW Normally open Wiper Control Wiper ModeWiper Wiper DwellSET Washer Sequence Received from the controller When the dwell time is finishedAUX LatchingClear Password Position Calibration Cycle Camera Power Reset, Cycle Power, RebootReset Camera Reboot SystemSoftware/Language File Upload Upload IconNtsc SpecificationsNTSC, PAL PALProduct Warranty and Return Information