Pelco C1300M-C (11/08) manual Regulatory Notices, Radio and Television Interference

Page 5

Regulatory Notices

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RADIO AND TELEVISION INTERFERENCE

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

You may also find helpful the following booklet, prepared by the FCC: “How to Identify and Resolve Radio-TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402.

Changes and Modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications CommissionÕs rules.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

C1300M-C (11/08)

5

Image 5
Contents ExSite Series Explosionproof Positioning System Page Contents Specifications Radio and Television Interference Regulatory NoticesWelcome Configure DoneModels Getting StartedHow to Operate Your System KBD4000/KBD4002 Genex Multiplexer Accessing Main Menu PresetKBD200A/KBD300A Direct Mode only Quick Start Guide System Setup C1300M-C 11/08 Language Unit Inversion OFF default Use for normal installations refer to FigureSystem Information Display Setup Label Positions Camera Unit SettingsDark IR CUT Filter 23X DAY/NIGHT CameraAGC Limit Advanced Camera SettingsShutter Speed Auto Sharpness Auto IrisAuto White Balance GainVideo Level Backlight Compensation BLCWide Dynamic Range 23X DAY/NIGHT Camera NormalMotion There are two proportional pan modes On defaultProportional PAN Amount of zoomPark Time There are three preset freeze frame settings Preset Freeze FrameScan Speed Image is never frozenManual Limit StopsScan Limit stop is reachedAzimuth Zero None Power UPPower UP Action System synchronizes to an internal clock Phase settings range from 0-359 degreesLine Sync Presets Edit Detection Areas 23X DAY/NIGHT Camera Enable Motion Detection 23X DAY/NIGHT CameraAUX Time 23X DAY/NIGHT Camera Activate AUX Command 23X DAY/NIGHT CameraTriggers a command to AUX Patterns Zones To set a window blanking area Window BlankingReverse Available OFF default No blankingClear Window Blank ALL ABOVE/BLANK ALL belowReset Delay AlarmsResume SequenceMEDIUM/LOW Normally open Wiper Wiper ModeWiper Control Wiper DwellSET Washer Sequence AUX When the dwell time is finishedReceived from the controller LatchingClear Password Position Calibration Reset Camera Reset, Cycle Power, RebootCycle Camera Power Reboot SystemUpload Icon Software/Language File UploadNTSC, PAL SpecificationsNtsc PALProduct Warranty and Return Information