Display Setup
PELCO EXSITE IPSXM
LANGUAGE | ENGLISH | |||
UNIT INVERSION | OFF | |||
<SYSTEM INFORMATION> |
| |||
<DISPLAY SETUP> |
| |||
<UNIT SETTINGS> |
| |||
<POSITION CALIBRATION> |
| |||
RESET CAMERA |
| |||
CYCLE CAMERA POWER |
| |||
REBOOT SYSTEM |
| |||
EXIT |
| |||
|
|
|
| |
|
|
|
|
|
DISPLAY SETUP |
| |||
|
| |||
|
|
|
|
|
PRESET LABEL | 2 (SECS) | |||
ZONE LABEL | 2 (SECS) | |||
ZOOM | 2 (SECS) | |||
AZIMUTH/ELEVATION | 2 (SECS) | |||
DIRECTION | OFF | |||
ALARM MESSAGE | 2 (SECS) | |||
<LABEL POSITIONS> |
| |||
RESTORE FACTORY DEFAULTS |
| |||
BACK |
| |||
EXIT |
| |||
Display setup allows you to program how labels are displayed on the monitor. The following labels are available:
PRESET LABEL | Identifies preset. |
ZONE LABEL | Identifies zone. |
ZOOM | Identifies the amount of magnification. |
AZIMUTH*/ | Amount of pan from 0° and the amount of tilt from 0° horizontal. |
ELEVATION** |
|
DIRECTION | Displays compass direction. |
ALARM MESSAGE | Displays activated alarm. |
A preset label is displayed when a preset is called. A zone label is displayed when the system moves into a zone. The zoom ratio label is displayed when zoom is activated. Azimuth/elevation and direction labels are displayed when pan/tilt is activated. An alarm message appears on the monitor when an alarm occurs.
The following settings are available for each label:
OFF | Label is not displayed when activated. |
CONSTANT | The label is continually displayed when activated. |
2 SECONDS | The label is displayed for 2 seconds after activation. |
5 SECONDS | The label is displayed for 5 seconds after activation. |
10 SECONDS | The label is displayed for 10 seconds after activation. |
*Azimuth is the pan angle from 0 to 359 degrees.
**Elevation is the tilt position from +90 (horizon) to
14 |
|