Pelco C1300M-C (11/08) manual Power UP Action, None

Page 26

POWER UP

PELCO EXSITE IPSXM

LANGUAGE				ENGLISH
UNIT INVERSION				OFF
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT


UNIT SETTINGS

<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<WIPER>
<AUX>
<CLEAR>
<PASSWORD>
BACK
EXIT


POWER UP


POWER UP ACTION				AUTO
BACK
EXIT

POWER UP ACTION

This setting defines a specific activity (scan, preset, pattern) to be performed in the event the power to the system is cycled.

The following settings are available:

NONE	No action.
AUTO (DEFAULT)	The system resumes its prior activity or direction before the power outage.
AUTO SCAN	The system starts auto scan operation.
RANDOM SCAN	The system starts random scan operation.
FRAME SCAN	The system frame scan operation.
PRESET 1	The system to preset 1.
PRESET 8	The system to preset 8.
PATTERN 1	The system pattern 1.
PATTERN 2	The system pattern 2.
PATTERN 3	The system pattern 3.
PATTERN 4	The system pattern 4.

26	C1300M-C (11/08)

Image 26

Contents ExSite Series Explosionproof Positioning System Page Contents Specifications Regulatory Notices Radio and Television InterferenceModels Configure DoneWelcome Getting StartedHow to Operate Your System KBD4000/KBD4002 Genex Multiplexer Accessing Main Menu PresetKBD200A/KBD300A Direct Mode only Quick Start Guide System Setup C1300M-C 11/08 Language OFF default Use for normal installations refer to Figure Unit InversionSystem Information Display Setup Label Positions Unit Settings CameraIR CUT Filter 23X DAY/NIGHT Camera DarkAGC Limit Advanced Camera SettingsShutter Speed Auto White Balance Auto IrisAuto Sharpness GainWide Dynamic Range 23X DAY/NIGHT Camera Backlight Compensation BLCVideo Level NormalProportional PAN There are two proportional pan modes On defaultMotion Amount of zoomPark Time Scan Speed Preset Freeze FrameThere are three preset freeze frame settings Image is never frozenScan Limit StopsManual Limit stop is reachedAzimuth Zero None Power UPPower UP Action System synchronizes to an internal clock Phase settings range from 0-359 degreesLine Sync Presets Enable Motion Detection 23X DAY/NIGHT Camera Edit Detection Areas 23X DAY/NIGHT CameraAUX Time 23X DAY/NIGHT Camera Activate AUX Command 23X DAY/NIGHT CameraTriggers a command to AUX Patterns Zones Window Blanking To set a window blanking areaClear Window Available OFF default No blankingReverse Blank ALL ABOVE/BLANK ALL belowResume AlarmsReset Delay SequenceMEDIUM/LOW Normally open Wiper Control Wiper ModeWiper Wiper DwellSET Washer Sequence Received from the controller When the dwell time is finishedAUX LatchingClear Password Position Calibration Cycle Camera Power Reset, Cycle Power, RebootReset Camera Reboot SystemSoftware/Language File Upload Upload IconNtsc SpecificationsNTSC, PAL PALProduct Warranty and Return Information