Pelco C1300M-C (11/08) manual Language

Page 11

Language

PELCO EXSITE IPSXM

LANGUAGE	ENGLISH
UNIT INVERSION	OFF
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT

The language for the on-screen menus is selectable. Available languages include English, Spanish, French, German, Italian, Portuguese, Polish, Russian, Turkish, and Czechoslovakian. The factory default language is English.

To change the display language:

1.Use the joystick to position the cursor beside LANGUAGE.

2.Press Iris Open. The cursor moves to the right, beside the current, selected language.

3.Move the joystick up or down to view selections. Press Iris Open to enter selection. All on-screen menus are changed to the selected language.

Quick Programming Guide

(See Page 9)

C1300M-C (11/08)

11

Image 11

Contents ExSite Series Explosionproof Positioning System Page Contents Specifications Radio and Television Interference Regulatory NoticesGetting Started Configure DoneWelcome ModelsHow to Operate Your System KBD4000/KBD4002 Genex Multiplexer Accessing Main Menu PresetKBD200A/KBD300A Direct Mode only Quick Start Guide System Setup C1300M-C 11/08 Language Unit Inversion OFF default Use for normal installations refer to FigureSystem Information Display Setup Label Positions Camera Unit SettingsDark IR CUT Filter 23X DAY/NIGHT CameraAGC Limit Advanced Camera SettingsShutter Speed Gain Auto IrisAuto Sharpness Auto White BalanceNormal Backlight Compensation BLCVideo Level Wide Dynamic Range 23X DAY/NIGHT CameraAmount of zoom There are two proportional pan modes On defaultMotion Proportional PANPark Time Image is never frozen Preset Freeze FrameThere are three preset freeze frame settings Scan SpeedLimit stop is reached Limit StopsManual ScanAzimuth Zero None Power UPPower UP Action System synchronizes to an internal clock Phase settings range from 0-359 degreesLine Sync Presets Edit Detection Areas 23X DAY/NIGHT Camera Enable Motion Detection 23X DAY/NIGHT CameraAUX Time 23X DAY/NIGHT Camera Activate AUX Command 23X DAY/NIGHT CameraTriggers a command to AUX Patterns Zones To set a window blanking area Window BlankingBlank ALL ABOVE/BLANK ALL below Available OFF default No blankingReverse Clear WindowSequence AlarmsReset Delay ResumeMEDIUM/LOW Normally open Wiper Dwell Wiper ModeWiper Wiper ControlSET Washer Sequence Latching When the dwell time is finishedAUX Received from the controllerClear Password Position Calibration Reboot System Reset, Cycle Power, RebootReset Camera Cycle Camera PowerUpload Icon Software/Language File UploadPAL SpecificationsNTSC, PAL NtscProduct Warranty and Return Information