Pelco C1300M-C (11/08) manual Label Positions

LABEL POSITIONS

PELCO EXSITE IPSXM

LANGUAGE	ENGLISH
UNIT INVERSION	OFF

<SYSTEM INFORMATION> <DISPLAY SETUP> <UNIT SETTINGS> <POSITION CALIBRATION>

RESET CAMERA

CYCLE CAMERA POWER

REBOOT SYSTEM

EXIT

DISPLAY SETUP

PRESET LABEL	2 (SECS)
ZONE LABEL	2 (SECS)
ZOOM	2 (SECS)
AZIMUTH/ELEVATION	2 (SECS)
DIRECTION	OFF
ALARM MESSAGE	2 (SECS)

<LABEL POSITIONS> RESTORE FACTORY DEFAULTS

BACK

EXIT

[ZONE LABEL ------------	]
[PRESET LABEL ------------	]
[ALARM 1 ------------	]

SAVE AND EXIT

CANCEL AND EXIT

HELP

XXX°/-XX°XXX.XX

Labels can be placed anywhere on the monitor. This feature allows you to customize the appearance of your monitor screen.

The following labels are not set at fixed positions:

Preset Label

Zone Label

Alarm 1

Azimuth*/Elevation**: XXX°/-XX°

Zoom Ratio: XXX.XX

Direction: Compass direction is shown.

To set a label position:

1.Use the joystick to position the cursor beside a label.

2.Press Iris Open.

3.Use the joystick to move the label up, down, left, and/or right.

4.Press Iris Open.

5.Repeat steps 1 through 4 to position other labels.

6.Position the cursor next to Save and Exit. Press Iris Open to save settings and exit menu.

*Azimuth is the pan angle from 0 to 359 degrees.

**Elevation is the tilt position from +90 (horizon) to -90 degrees.

Quick Programming Guide

(See Page 9)

C1300M-C (11/08) 15